Hi Alain, Thank's a lot for all your explains. I have a fixed prop and 2 years ago I got 3000 rpm with about 8 knots max speed. Two years ago, all the prop entretien was done by AMEL specialist at La

Hello Wolfgang; On our 54, we have the 11KW generator also. The water and exhaust exit the hull in two separate holes. The water is the smaller hole just forward of the engine exhaust. It is easy to

Wolfgang, I haven't answered because I am not 100% sure and was hoping someone else would answer. I am95% sure because I read the 54 Owner's Manual page 5-1 which states that the Generator water

Thanks a lot all i will order it tomorw Best SY Balu 222

Hi Philipn, I have a TMD22 too and a Maxproip. My max speed is 8knots at 3000rpm. Most of the time a change in performance and/or important top speed change is due to somebody having changed the pitch

Hi all Again I say. TMD 22 in Amel SM. Max revs under power is 2800rpm. If you were getting 3500 almost certainly the waste gate on the turbo was seized and the engine was being over turbo'ed. This

On SM#387, it was Calpeda BCM20E available from Veco. Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School www.amelschool.com 720 Winnie St Galveston Island, TX 77550 +1(832)

Eric & Kent, I think the answer is obvious. Any non-modified and totally original Amel-installed SSB will receive and transmit very little RF from the Amel-installed electric devices, such as battery

Thomas, We have a Mastervolt EasyView display installed at the nav table. It is a very easy to use device once it has been set up, but setting it up "from itself" is very, very difficult.

Good morning Philipp, Same here, I will not exceed 2300 rpm while the boat is moving. If at the dock (boat attached) then I can reach more. I was told this is because of the propeller being

Hi Chris , If you have the 78hp Volvo , which I guess you do , Amel governed it down to 60hp ,2800 revs , because above that you are just burning fuel to no effect . At 2800 with a clean hull and

See my previous. 2800rpm is the correct Max operating rpm for the tmd 22. Whatever any one else may tell you. Regards Danny SM299 Ocean Pearl Sent from my Vodafone Smart On 25 Jun 2017 09:16,

Hi Trevor, The hull and the prop were cleaned completely last year and I had the same situation not more speed than 6 knots. I thought also about barncacle growth but after cleaning hull and prop

He Rink Thanks a lot SM Balu stay in Greece by 25.07 in Messolonghi then we raund for 5 weeks the Pelepones Maybe we see us Elja

Hi Philipp, How is the cleanness of your prop and hull? No barnacle growth? Trevor SV Iris, SN027 Phuket - on the hard

Hi all, Does anybody has an idea what I still can do with my engine (TMD22), that I get back my speed from 7 knots with 2300 RPM and with the max RPM of 3500 and a speed through the water with 8

Hi Elja, You can find some more posts about this at the group site. If it is the same as on our SM2K 2001 it is a Calpeda B-CM 20, sold through Climma/Veco. You can find details on the

Hi Chris, I have just changed my turbo charger and I don't get 3500 RPM at the moment. An overhaul of the trubo is for sure not bad, but maybe you won't get your envisaged result. I thought first that

Hi again Chris, I got so excited about the rpm ,I forgot to tell you that if the prop with a missing blade is a auto prop you can buy new blades for it from Bruntons the manufacturer. Either singly or

Hi Chris, if you have the Volvo TMD 22 78hp 2800rpm is the correct max revs. Many of us sweated over this for years without knowing this. I will say it again. 2800rpm is the correct max revs for the