Hi all, We lost the cover for the engine room ventilation output on the port passageway on our Amel 54. It's a simple vent cover but we haven't got any reference to replace it. Would it be possible

To All, My thoughts and prayers go out to all the people that were in the path of Irma. Is there anyone close to Alex that could pick him up and take him somewhere safe.... maybe Martinique.... I

Hello, One of the sheaves of my main sheet traveler car has broken. Does anyone know where I can get a replacement? Thank you very much, Peter

Bill The B&G Hydra 2000 depth works at 170kHz Cheers Alan Elyse SM437

Alan, The P79 works at both 50 and 200 kHz, so I am guessing the Hydra runs at 83kHz? Or is it something unique and proprietary? Bill Kinney SM160, Harmonie Deltaville, Virginia

Thanks for your comment. Vladimir Sonsev Tel/Text: 202 258 1916

RE P79 Note that this sensor DOES NOT WORK WITH B&G HYDRA, it is the wrong frequency. Cheers Alan Elyse SM437

Vladimir, I have used that type of transducer and several other Amel owners have as well. They are made by Airmar, and are known in their catalog as a "P79".

Raymarine offers depth sounder that does not require a hole in the boat. It works through a fiberglass bottom. Did anibody used it type? Vladimir 202 258 1916

A year ago I replaced my Sonic Speed with a Airmar CS4500 ultrasonic speed sensor. It has been perfect. Reliable and accurate. Readings are stable and responsive. It does not have the electrical

Hi Kent, I installed a DST800 about 3 years ago on Aloha for my Ray Marine instruments. Had to remove the transducer from a dead forward looking sonar unit, enlarge the hole, and install the DST800.

I'm leery about the DST800. Marine Electric Services says they are prone to failure and don't recommend them any more. Kent Robertson S/V Kristy karkauai@... Panama cell: +507-61171896 USA cell:

Look at www.SVB.de Part Nr. 11637 Best regards Leo SM YinYang #69 Von meinem iPad gesendet Am 13.09.2017 um 13:47 schrieb mark_pitt@... [amelyachtowners] <amelyachtowners@...>:

Derick, Do you know the part number of the replacement ring? Do you have a source? I need to buy one. Thanks. Mark a Pitt, Sabbatical III, SM419, Mallorca

Mike, Thank you for your advise. It was very helpful. I removed old seal today as you recommend. Vladimir Sonsev Tel/Text: 202 258 1916 SM 345 "LIFE IS GOOD"

For photos of the cover see the album "Cockpit Dodger Cover"

Mike, That was very clear and much appreciated. Best regards, Duane Wanderer, SM#477

Hi Mark. We are in Langkawi, Malaysia.

Thinking about it the tiller is curved but doesn’t come passed the mizzen mast

Thank you Warren, I will empty the cockpit lazarette this weekend. I find new things all the time. Is the tiller curved or just off centre? Mark