Just made that week, ordered at hdi marine , price round 200 usd , I choose a cast stainless steel better resistance to corrosion .

Well Done Jeff!!

Good Morning. Thank you all for your friendly advice regarding my turbo replacement/long term maintenance. Along this same topic, I am looking into replacing the mixing elbow. On my TMD22 the

Jeff, Congratulations! Well done! We are happy for you. SM 345 "Life is Good" Vladimir 202 258 1916

Hello Bali Hai, I bought my AMEL new from the factory in 1998. The roller furling is original. The boat has always been called Ladybug. Regards, Miles Ladybug, s/m 216, preparing to leave my storm

Good News! I watched Jeffdock Spirit in TCI earlier this year. It was blowing really hard. He nevertouched a pylon. With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K

Nice achievement indeed. Good sense too. Docking single handed is all about preparation… and a little help occasionally. Depends on the factors in play on the day. But then … I’m talking to

Jeff - Obviously a prudent strategy, on a trusted vessel, with great seamanship. If anything, I hope this season starts a lot of discussion on avoidance planning. When 100nm can mean the difference

What an absolute stud. So happy to hear this news!

Wow - well done Jeff. The 20 knot tie up single handed must have been a challenge. Best wishes Peter Forbes Carango Amel 54 #035 00447836 209730

Way to go Jeff. I wonder why so few people didn't make the same smart move. I am glad you are safe. CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School www.amelschool.com 720 Winnie

I just received a note from Jeff on his Amel 54. He left the South west coast of Puerto Rico before Maria and headed south. He encountered winds to 40 knots and seas 8-12 feet. He returned to the

Miles, Do you have a standard roller furling genoa? Was the boat formerly “Jazz”? Ric Gottschalk SN24 Bali Hai Annapolis

Thanks Miles! Will do that! Cheers, John C'est si Bon

Hi Miles, Are you still looking for crew? I found the person I need and have 3 or 4 that seem good. If you still need crew, I will ask them to contact you. Fair Winds Eric

Mike, Don't feel bad , three years ago I had mine rebuilt , and a few days ago I could not remember why . Finally , a few days later , I remembered it would get so hot it was smoking . For a while I

Hello C'est si bon, In my pre-AMEL days, I had a boat on which the swivel stuck. Some one from Hood sails told me to do this: run water through the swivel, then soak it with WD-40. Then wash again

Hello Gents, I too went through the TURBO overhaul… twice! A very smart diesel engineer told me the following to avoid the thing seizing… which it typically does during the off season when the

Thanks Mark McGovern for this valuable information. This challenge will be faced by every TMD22 owner. For those that don't know, Mark is the president of TurboXS. Best, CW Bill Rouse Admiral, Texas

Pat, I was afraid you’d ask that. I didn’t say because I couldn’t remember. As I recall I did drop it off to their shop on the way home from Rock Hall, but I don’t recall why they felt it was