Mark, We ordered the same switches and found them to be way too small as well. Unfortunately, one of these was meant to be put into use right away. I am currently in the process (3 days now) of

Eric, Thank you for the list. For information, I will be here except for the period from 7 Jan to 29 Jan. I would like to meet other Amel Owners during this time. I have found that each

Hello Craig, Many years ago, Amel told me to never adjust the bow thruster the way you have done. Making the lift motor raise it to the pin puts too much force on the motor. It should stop where

Duane, Check the 3 small capacitors. In my case the same thing happened due to low fan speed the thermal switch turned the heat off. Fair Winds Eric Kimberlite Amel Super Maramu #376

Duane, As usual, Bill from Bebe has a Photo Album about this subject with some helpful information here: https://groups.yahoo.com/neo/groups/amelyachtowners/photos/albums/324976668 You might have an

Duane, Oops sorry.Just saw the EH in your email. Forget the valve, you don’t have one. With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising

Duane, Is this areverse cycle unit? Or, do you have a heating element? If it isreverse cycle, there is a reverse cycle valve that can stick (I hope youproblem is this easy). The valve makes

Hi Duane,What fan speed are you operating it at? I read in the manual that you must use medium or high when heating, and I can confirm that mine shuts off if I use it in low. I assume there is a

We started the aft cabin Climma heater today and it's not working. It starts to heat, based on my hand on the air outlet, but after 10 seconds or so blows only cold air. So the heating element (we

Hi all, I ordered someof the buttons below to have as spares in case the replacement buttons Iinstalled from Vetus fail. However, when they arrived I found they are way toosmall for the holes in

My SM does not have the off switch in front of the pin, and does have the little locking post that keeps the pin in. I thought the off switch was added with the SM2K. Ryan SM 233 Iteration Boston,

Thank you to all who responded. I'm going to leave the adjustment as is and continue to use the cable grab method for inserting the pin. It makes sense to me to keep the tension off the cables and

Courtney, Bob here from Gallivant, 54 #31. I would like to talk to you on the phone if you can about the D3. You can reach me at 585.409.9869 Gallivant Amel 54 #31 currently on St. Thomas

Paul, It is correctly adjusted if you have to pull the wire to raise it about 10mm. About 11 years ago I discussed the adjustment of the wire with the Amel Service Manager in the Caribbean...he said,

We arrived yesterday and are parked about 3 or 4 Amels away fromKimberlite. With bestregards, Mark and Cindy Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising -

The Super Maramu has the on off switch in front of the pin. You cannot operate the bow thruster with the pin in place. Fair Winds Eric Kimberlite Amel Super Maramu #376

Granted we're only talking millimeters, but it seems the lifting action should stop exactly at the level at which the pin can be inserted without squeezing the cables.. This will provide the proper

I also forgot to ask if you have the yanmar engine? Fair Winds Eric