Hi Kent, I bought a new switch plate from Climma 2 years ago and now the thermostat has failed--however you turn it, it won't "click" and the heater won't come on, though the fan works OK. When

Hi cousins, Iris and I are heading S from Jacksonville FL in a couple of weeks. We are hoping to get involved in the hurricane relief effort somewhere. We could bring supplies or equipment, help in

I had a thermostat fail last year. Parts are available to rebuild your controller rather than purchase a new one. Kent SM243 Kristy

Hi Miles, Interesting advice from "Amel", although lacking a "why" makes me wonder. I've set my BT so when retracted the "donut" gaskets are gently compressed AND the hole in the lift is just a

The thermal cut off is located on the upper right side of the frame of the heater. The heater looks like an old time toaster. However, I’ll bet it’s a low reading capacitor. It is one of the 3

Ryan, Mark, Mark, Eric and Bill, Thanks all for your comments. This is a great resource. I'll look for Bill's photo instructions. Bill, I'll be checking the cap's tomorrow and have the replacements

Hi Miles, Interesting advice from Amel I think it's a bit odd, frankly, and it seems not to have come with a "why" do this.. I rather think the logical adjustment, which I've done, is to have it

Mark, I just saw the switches delivered from Amel and new plastic switch sleeves we're delivered with the switches...maybe I can get a photo tomorrow. CW Bill Rouse Admiral, Texas Navy Commander

I am 99% sure the fan speed is too slow which is tripping the thermostatic safety switch which is getting too hot because of low fan speed. If the heat is turning OFF with the fan on high, check the

Mark, We ordered the same switches and found them to be way too small as well. Unfortunately, one of these was meant to be put into use right away. I am currently in the process (3 days now) of

Eric, Thank you for the list. For information, I will be here except for the period from 7 Jan to 29 Jan. I would like to meet other Amel Owners during this time. I have found that each

Hello Craig, Many years ago, Amel told me to never adjust the bow thruster the way you have done. Making the lift motor raise it to the pin puts too much force on the motor. It should stop where

Duane, Check the 3 small capacitors. In my case the same thing happened due to low fan speed the thermal switch turned the heat off. Fair Winds Eric Kimberlite Amel Super Maramu #376

Duane, As usual, Bill from Bebe has a Photo Album about this subject with some helpful information here: https://groups.yahoo.com/neo/groups/amelyachtowners/photos/albums/324976668 You might have an

Duane, Oops sorry.Just saw the EH in your email. Forget the valve, you don’t have one. With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising

Duane, Is this areverse cycle unit? Or, do you have a heating element? If it isreverse cycle, there is a reverse cycle valve that can stick (I hope youproblem is this easy). The valve makes

Hi Duane,What fan speed are you operating it at? I read in the manual that you must use medium or high when heating, and I can confirm that mine shuts off if I use it in low. I assume there is a

We started the aft cabin Climma heater today and it's not working. It starts to heat, based on my hand on the air outlet, but after 10 seconds or so blows only cold air. So the heating element (we

Hi all, I ordered someof the buttons below to have as spares in case the replacement buttons Iinstalled from Vetus fail. However, when they arrived I found they are way toosmall for the holes in