Hi Mark, Yes Yahoo is sometimes funny about the attachments. Let's try again. Well it looks like it loaded but then gives an error message. I will try to send to photos section after typing. See

Olaf, I agree with Bill R. and Mark. I used Stephanie last year for my SM purchase and she (and JP) were great to work with. Stephanie helps with all the paperwork and smoothed the way for an

Hi Stephanie, I too need to do something with our decals. I saw a picture of an SM that had replaced the side decals with polished stainless steel that looked terrific. I think it was SM007

ThanksBill. Mye-mails still bounce back. It may be something on our end. Do you have analternate e-mail I could try? Mohammad and Aty B&B Kokomo Amel 54#099 From:

John, I do not see any attached wiring diagram and I did not see anything in the Photo section either. However, that might just be me! Check that you attached the wiring diagram be sure. That said,

Well, I guess I am undergoing a similar evolution right now installing a whole house inverter for the first time. I posted my wiring plan in a new topic. I think as Bill K said most modern

Bill, Your plan looks sound. I replaced the 12 batteries in my SM2k last year and followed a similar procedure. I agree with James that it would be best to load test each battery before installing

M&A, That email, Bill"at"AmelSchool.com, is working. I just tried it. I worked with both of the following people there: Andrew Wilson - Commercial Manager awilson@... Joanne Mifsud - Executive

Hi Bill, that sounds good to me. I opt for pictures over hand drawn wiring diagrams now that "digital film" is so inexpensive. ;) James' advice to check each battery individually is good

Bill, First, Prop Speed is still widely available. I am not sure why your local guys can't get it. Assuming for whatever reason it can not be locally obtained, Velox is another product that works

Hi All, I am installing a“whole house” inverter/charger, a MagnaSine 4124 (230v/50hz.) I explained to the vendor, Inverter Service Center in Tennessee , how the Amelelectrical system has a

Bill, The only thing that I can think of to add would be to insure that the new batteries were individually all at a similar state of charge before connecting them. It might also be a good idea to

We recently did bottom paint and used Velox on the prop for thefirst time based on good reviews. It is readily available in all the Caribbean shipstores. It is easy to apply but you must remove every

Two years ago I treated my Max Prop with Prop Speed to protect it from critters underwater. I asked Peake Yachts here in Trinidad where I'm hauled out if they could reapply the Prop Speed (maybe its

My 8 Lifeline AGM 105 AmpHr batteries are pretty much gone so I've ordered 8 new GPL-31T 105 Am Hr batteries from DC Battery in Fort Lauderdale and had them air air shipped to Trinidad. The cost of

Hi, It is best to post your boat type and serial number when asking a question. Fair Winds Eric Kimberlite Amel Super Maramu #376

I have replaced my broken wired NASA Clipper with the wireless sensor unit. Works fine, is cheap and data is transfered fast enough. So no problems. Gerhard Sharki #80

Colin, Your email didn't survive encoding by Yahoo, so I'll answer here... I installed the Multiplus in the engine room, using the existing cables from the old charger that it replaced, although I did

Here's another experience with the Xantrex: My original Xantrex 1800 was installed (by a professional electrician) in Dec of 2016. It failed in July of 2017 and was replaced by the manufacturer,