We are interested in getting together this Summer. Our boat is on a hard in Herrington Harbor now. Vladimir SM 345 "LIFE IS GOOD"

Vladimir, Thanks for the offer and I am glad that you did find the oversized rivets. I don’t think that I want to use the flush heads because I don’t want to cut away any metal for the

Ha! Thanks Mark, yes I am planning to purchase from Go2Marine. My evaporator and thermostat look like they are in good condition. I thought about the whole package but since the quick connections

Hi Steve, How do you include a photo into text on this site? Fair Winds Eric Kimberlite Amel Super Maramu #376

Thanks Steve. On May 8, 2018, at 6:15 PM, Stephen Morrison steve_morrison@... [amelyachtowners] <amelyachtowners@...> wrote: I will take a few photos and some measurements and email them

Sounds like a good product, Pat. Let’s get together. Anybody else on the Chesapeake (or anywhere else) want to have an Amel Rendezvous this Summer? Kent Robertson S/V Kristy SM243 karkauai at

John, We replaced ourunits a couple of years ago. I would also suggest you replace the evaporatorunit at the same time giving you an entire new box ready to last another 20years. The evaporator

John, We replaced ourunits a couple of years ago. I would also suggest you replace the evaporatorunit at the same time giving you an entire new box ready to last another 20years. The evaporator

I will take a few photos and some measurements and email them to you, but Houston did it all on his own. I just asked if it might be possible to combine them all and then picked up the boom a week

Olaf, I agree with everyone else's and your assessment that something is not right. Get yourself an inexpensive Battery Tester like this one:

Hi Mark the balance of your boat is ok. Btw you have a lot of black patch on your port side . I 'dont have that , even motoring longtime. regards Hanspeter Tamango 2 SM16 Teneriffa Von meinem iPhone

Kent, I have been following your exploits and Diane picked up your AIS on Marine traffic when you left the Carolina's. The ColorWheelz still looks brand new after at least eight years ,and we never

Hmmm, I’ll try that again. Do you have drawings for the boom connector you had made? Thanks Kent SM243 KRISTY On May 8, 2018, at 1:09 PM, Stephen Morrison steve_morrison@... [amelyachtowners]

Good point Miles, I can go and check how many hours between the seal changes but I know that the last time it was leaking water as we were finishing our dobule transatlantic crossing which included a

Hi Bob, The 90w gear oil behaves pretty much like the old 15w-40, turning progressively more white-ish. Like the 15w-40 in emulsifies into a pretty thick white grease, like cold creme, but still

A bit of a twist on this issue. Like many of us I am now using 90w oil vs 15-w40 and it is lighter colored. Used to be that it was lighter and then milky. Just curious, has anyone noticed how 90w

Hello Jose, I wonder what grease you are using. I change my wearing out bearing every 650 hours or so using the Amel pattern. I have done this for 20 years and I have never had any leakage of any

Hi John, Thanks for the info. You bring up a good point, unfortunately I didn't make a note of how the boat sat before I put the solar on. The exhaust port is probably 3/4 under water when the boat is

James, Thank you very much. I found oversized 1/4" diameter. I want to get flush head, aluminum CR 3252. Box of 100 is a minimum order. What are you buying? Perhaps we can split the box 50-50. Are

I didn’t knowingly do anything smart. I’m on my phone as was the photo, and while I was typing my response to you I just dropped down a couple lines (hit return) and then held my thumb on the