BTW--during the correspondence and postings I referred to the surface as "stainless". I realize that the material is most likely chromed. Bob

Hi Peter, I installed a constant pressure/variable output Marco Pump E12 a few months ago. No accumulator tank needed either and sufficient pressure to wash your decks! Jean-Pierre

Jean- Pierre, I assume that would be logical considering the torque curve. I agree, I don't want to know what 4500 revs sounds like. Looks like you find yourself in a Bit of Paradise ! Enjoy I'm

EASY. Close the Through hull. Use a manual bilge pump/wet and dry vacuum cleaner and empty the pipe. Then fill the pipe with household white vinegar.. let stand 24 hours and reopen the through

Hi Pat, Volvo says their engine can deliver unto 4500 rpm. However, because power is not fully dependent on rpm but on torque, Amel decided to accept 3000 rpm as the normal maximum rpm. This is

Greetings all, I am a first time poster and proud Amel Owner. First off, I want to thank publicly Joel Potter and Bill Rouse. They went the extra effort in answering and guiding me through the

Hmmm, have you tried it yet? Maybe not an ideal situation. Kent Robertson S/V Kristy SM 243

---In amelyachtowners@..., <karkauai@...> wrote : Does anybody know the size of the Speedi-Sleeve needed for the WOB? I remember someone posted it but can’t find it now. If 316 stainless isn’t

Does anybody know the size of the Speedi-Sleeve needed for the WOB? I remember someone posted it but can’t find it now. If 316 stainless isn’t hard enough, what material is recommended for a

Bob, thanks for the report. The results you show are impressive. Craig, we are in total agreement. One way or another this problem will be resolved, at least for those of us who seem unable to

Bill, The quote described it as 22x16 70 mm hub , I took a couple of measurements of the diameter with a caliper , two as it is tapered . I will confirm with Maud before placing an

Ruedi, Here is her contactinformation: Maud TOUILLET Service clientèle – Customer service sav@... Phone : +33 (0) 54655 00 75 With bestregards, Mark Skipper Sailing

Hi Ruedi, When I tracked down the leak it was the cables from the control box on the shelf going to the TV. Took out the old TV and can still use the Bose system for radio only. The CD/DVD in the

Ruedi, You can email Maud at "sav at amel.fr" Mark McGovern SM 440 Cara Deale, MD USA

Hi Barry Yes I have Bose installed, GOOD idea. Have check-it out without success :-( The problem is that the leak is appearing very erratical and I haven’t found the pattern yet. Thanks,… will

Dear Amelies I have seen that some of you are talking about a lady called Maud @AMEL where you can get parts from. Can someone give me her e-Mail Address? I’m new with AMEL and I would very much

Pat, For the classic model MaxProp, the pitch is adjustable over a wide range, so for purchase the numbers that are critical are the prop diameter and the bore for the shaft. If you need

Roger that. Interested. Standing by. Ian S/V Loca Lola II SM153

Ian, They just sent me a quote for a 3 blade classic 22x16 for $3450. Per Joels suggestion I am going to speak with Maud and see what the pitch was when Amel installed Max props on the SM years ago,I

Bill, Thanks for the referral. I called them and talked it over. I'm going to take it to them tomorrow. It's hard to tell much about them based on their shopfront, it looks pretty low rent. Thanks