Second time now the muffler just melted away because no water - impeller is ok - hoses are all clear, filter is clean - any ideas? Robin Amel 54 # 54 Carré d‘As Menorca

Good day to you I went thru the same 3 years ago & can vouch for the fact that a self survey can be as effective than one conducted by a surveyor without experience on Amel boats. Check my earlier

Greetings and Salutations, I am conducting a pre-purchase self survey of a 1986 Amel 46, hull number 188 as part of my consideration for purchase. I have been reading the historical posts on the Amel

Hi Miles, The attachments didn't attach...

Hi Bill: I think this is a mounting problem with the glassed in shelf. I used a torpedo level placed on the shelf showing 1/4th bubble outboard and that was matched with 1/4th bubble outboard on the

I’ll try it Craig. Kent S/V Kristy SM243 Kent, As I recall you've got a FEIN Multitool - there's some flat saw blades for it and a "window cutter" that could just do the trick. Craig

Gary, Interesting, because I believe the Onan on SM #387 tilted slightly inboard. At least any spilled fluid would move inboard. This makes me wonder if maybe the pan might be slightly concave causing

Kent, As I recall you've got a FEIN Multitool - there's some flat saw blades for it and a "window cutter" that could just do the trick. Craig ---In amelyachtowners@..., <karkauai@...> wrote : Thanks

Hello Jose, there has been two kinds of Sonic Speed sensors used by AMEL. The first ones (until around 1995) were glassed in the hull/keel stub and impossible to replace without digging and

Thanks Craig. I’ve been trying that with little success so far. I’ll keep plugging away. Kent Robertson S/V Kristy SM243

Hi All: I don't know about you but one of the things that I believe Amel got wrong was the level of the shelf that the Onan Genset sits on. It slants outboard and all the Amel SMs that I have

Miles, I owe you a navigators secret decoder ring. Ric Bali Hai SN24 Annapolis

Hi Ric, http;//fermi.jhuapl.edu/avhrr/gs/averages works if you take the period off the end! Thank you. I had not known about this one. The single satellite pass picture gives a truly graphic

Hi Kent, Ours are simply held up by the screws going up through the frame, not by any fasteners coming down. Doubt yours are different. If you've got all the screws out and it doesn't fall free, maybe

I couldn’t do it with my iPhone from the site itself. If you reply to an email notification, you can insert a photo as you would in any other email. Kent S/V Kristy Hi Kent, How do you include

Hi Danny, I suppose I could, but it’d be difficult to do a nice job on the top and aft end...and potentially messy. If I cant figure out how to get them off, I guess that’s what I’ll have to

Alex, whom mine died it was the sensor that detects the magnet, replaced that and voila working again. Sent from Yahoo Mail for iPad

it‘s the ine sold by quick (svb.de about 320 €) and it fit but we had to enlarge the hole in the cockpit (Lewmar was 3 little holes - Quick is one big hole - sensor did fit after a bit of

Hi Kent, How do you include photos in the text on this site? Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Kent. Why don't you varnish them in place. Regards Danny SM 299 Ocean pearl