Thanks Eric, it went well and fast using a router. Didn't do much for the bit ,probably trash that. Problem now is getting the SS nipple unscrewed from the end of the car, so that I can slide out the

Hi all, The problem was in my shore cable. I have no clue as to why this failure happened exactly when my generator was started up. Maybe it’s related, maybe not. I have now fixed my shore cable,

Pat, Nice photos, nice work. Thank You, Eric Kimberlite Amel Super Maramu #376

HI, On Kimberlite, there is also a time delay switch in the transfer box that “waits” a few seconds before energizing the transfer relay. It is similar to the ones in the climma AC units.That

The switch has checked out perfectly. The shore power (quai) contractors are normally closed, and the generator contactors are normally open. when the generator starts, the shore contactors are

Ok, inside there is a changeover switch, so we are in the right place :-) It’s a Telemecanique LCI D40008 ... so now I will find the specs and carry out some tests ... Thanks Alexandre and Mark.

I don’t know what to look for… something burn? May be it is a magnet that moves? I wish Olivier would enlight us with his knowledge !!! (Don’t forget to disconnect the shore power) Sincerely,

Hi Alexandre and Mark, Thank you for that pointer... I have found the box on the port side of the engine room and I will take a look inside now. Is there anything to observe on the unit which would

Dean, We had that same switch fail in a similar fashion on our Super Maramu. On the SM, this changeover switch is located in the engine room on the port side right outboard of the generator. It is

Good morning Dean, First of all sorry for your mishap, but congratulation for the maintenance you did on the generator! On my SM2K, cleaning well the raw water pump, eliminated the faster than

Hi, Today’s job was to replace the impeller in my generator. It was shredded, so I opened up the heat exchanger to clean it too, it was gunged up badly, so after cleaning all that I had a look at

Kent, That joystick is IDEC HW1MF0202-20 available on-line from Newark element 14 company for $67.99. Craig ---In amelyachtowners@..., <sangaris@...> wrote : Hey Kent, I did mine 4-5 years ago - found

Hi Craig, I would be interested in the R/L switch as well. Thanks for looking it up! Duane

Thanks again Pat. Steve

Hey Kent, I did mine 4-5 years ago - found a good replacement that has lasted and, frankly, looks a bit more modern than the original. I'll look for the details and let you know. Craig SN68

Thanks Duane. Did you look for a replacement for the bow thruster R/L toggle switch? Anyone else have a replacement part for it? Thanks Kent S/V Kristy SM 243

Mark, My wife just added the pics of the genoa track cut out to the photos in the Shenanigan photo file . Diane put a link in a post yesterday to the pics. Hope this helps,any questions contact

Steve, I mailed the template today and added a few more pis into the Shenanigans photo file, there were more but too blurry to add. If you have any questions or want pics of anything in particular

Hi Alexandre, The Blue Seas parts were about the same cost, but easily available in lieu of shipping from France. I'm hoping the BT genie is happy now. I've replaced the Limit Switches, the Actuator

Arthur, Not sure if you have this resolved or not, but I have a spanner/wrench for the rudder post nut on an Amel 55 which measures 85mm wide x 10 mm thick. Also, I am currently at Marina Real in A