Hi Drew, I sent you a drawing of the shaft brake cylinder. You have an O ring that needs to be replaced. It is a very simple job. Fair Winds Eric Kimberlite Amel Super Maramu #376

---------- Original Message ---------- From: Danny and Yvonne SIMMS <simms@...> To: amelyachtowners@... Date: 13 August 2018 at 10:08 Subject: Re: [Amel Yacht Owners] Anchoring in deep water in

---------- Original Message ---------- From: Danny and Yvonne SIMMS <simms@...> To: amelyachtowners@... Date: 13 August 2018 at 13:36 Subject: Re: [Amel Yacht Owners] Anchoring in deep water in

Thanks for your help. I have a new kubota d11 05 with a sincro sk160. The hoses are the easy part. Not sure about the skin fittings. Michael Sent from Yahoo7 Mail on Android

Thanks Bill. We are installing a sincro sk160 mated to a kubota d11. It is a little more powerful than the original onan. The old engine was damaged by corrosion in two cylinders. The information

We removed ours for the first time about a year after we bought the boat when we renewed the seals on the gearboxes. I do not know when the last time it had been taken apart. The only tool I needed

Eric, When you say you have "not enough pressure" are you talking about the output from the high pressure pump? Or the pressure between the feed pump and the high pressure pump? Bill Kinney SM160,

No, all I know is what I gave you. I don't know how you could exceed max pressure if you stay at, or under liters/hour. Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School

Oh, misunderstanding on my part. So you leave it all connected and run the rope rode down the hawsepipe into the chain locker and drop the chain in on top of it? ALAN said his was permanently

Hi Kent, You can't use a thimble and shackle, they wont fit out of the hawse pipe. You have to do a splice onto a thimble anyway so splicing to the chain is no big deal. Regards Danny SM 299 Ocean

Thanks Danny, great advice! I like attaching the line to both anchors. I assume that with 300 ft of chain, the rope rode will be well above the bottom. I’m calculating that in 40 meters, I’ll

Eric, "The specifications of the low pressure pump are : 300W 900l/h. Best regards Secretary Dessalator Rosyne Castino" Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School

Before considering using two anchors, everyone should read this : https://www.petersmith.net.nz/boat-anchors/tandem-anchoring.php Cheers Alan Elyse SM437

I think its much simpler, merely a pulse train. Its the same for the "Ultrasonic" connection. I put in an Airmar Ultrasonic speed transducer and connected it to the "Ultrasonic" connectors on the

Hi Eric I don't know what the black stuff is....ours is beige ! BUT I drilled a hole throughb the wall for the voltage and temp sensor wires for the new battery chargers. Drilling the hole and sealing