Eric, That's a first! What was it? And, do you have any idea how it got past the first prefilter? Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School

Hi Bill, I found the problem. It was none of the above, Thanks For the help. There was something lodger between the 2 pre filters. Fair Winds Eric Kimberlite Amel Super Maramu #376

re Danny's prior comment: "... tandem anchoring. Attach 10 m of chain to the hole in the leading edge of your primary anchor and add the second anchor to that. Then take 13 metes of floating line and

Hi all, On my A54 #69, I opened the aft berth to inspect the steering and found some grease dripping out of the steering cables. See attached photo. You can see a bit of grease on the cable itself,

I’ve been reading about “bommies” Danny, it must be a royal pain if you get wrapped around one. Can you generally see how it’s wrapped to aid in getting it free...or is it just a matter of

Great, I’ll use the same setup. Kent Robertson S/V Kristy SM243

Il 13/08/2018 11:28, divanz620@... [amelyachtowners] ha scritto:

Eric, I have seen growth, barnacles and mussels pack the line from the sea chest to the saltwater manifold. mussels especially like this area because of the waterflow caused by the AC pump when in a

Seems to me that a lot of these issues could be solved / eliminated by using sealed batteries...like AGM If all the regs are set correctly there should be no gassing form VRLA (AGM) batteries and

Hi Giovanni I have a switch that disconnects the alternator field from the Next Step regulator for the same reason. if the batteries are full charged from shore power or solar, I don;t want to start a

Il 12/08/2018 21:22, divanz620@... [amelyachtowners] ha scritto:

Hi Bill, The pressure from the low pressure pump. Fair Winds Eric Kimberlite Amel Super Maramu #376

Arthur, The photos are on the way. Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Drew, I sent you a drawing of the shaft brake cylinder. You have an O ring that needs to be replaced. It is a very simple job. Fair Winds Eric Kimberlite Amel Super Maramu #376

---------- Original Message ---------- From: Danny and Yvonne SIMMS <simms@...> To: amelyachtowners@... Date: 13 August 2018 at 10:08 Subject: Re: [Amel Yacht Owners] Anchoring in deep water in

---------- Original Message ---------- From: Danny and Yvonne SIMMS <simms@...> To: amelyachtowners@... Date: 13 August 2018 at 13:36 Subject: Re: [Amel Yacht Owners] Anchoring in deep water in

Thanks for your help. I have a new kubota d11 05 with a sincro sk160. The hoses are the easy part. Not sure about the skin fittings. Michael Sent from Yahoo7 Mail on Android

Thanks Bill. We are installing a sincro sk160 mated to a kubota d11. It is a little more powerful than the original onan. The old engine was damaged by corrosion in two cylinders. The information

We removed ours for the first time about a year after we bought the boat when we renewed the seals on the gearboxes. I do not know when the last time it had been taken apart. The only tool I needed

Eric, When you say you have "not enough pressure" are you talking about the output from the high pressure pump? Or the pressure between the feed pump and the high pressure pump? Bill Kinney SM160,