Having just disassembled all of the various stainless bits from the bow of Harmonie for resealing, polishing, and inspection I can confirm that the axles for the anchor rollers are welded to the side

Mark, Thanks you for the correction. My math was for 12V rather than 24. So hopefully the following is correct: If your SM is equipped with 8 12V, 110Ah batteries and you are drawing 0.1 Amps

Graham, Like you I think a lot of sailboats are significantly overpowered because that is what people think they want. Your thoughts on the Beta 60 are interesting, and I'll follow carefully what

Thank you for sharing your resersh and knowledge. Kind regards Arthur SM435. Vista Skickat från min iPhone 16 nov. 2018 kl. 14:56 skrev greatketch@... [amelyachtowners] <amelyachtowners@...>:

Highly recommend the 40kg Rocna. After bending the shaft on the original 30kg Bugel (see YouTube How to straighten a bent boat anchor) the Bugel bent whilst being dragged in 40 knot winds. The new

10mm G40 (or 3/8" HT) If you want a slightly stronger chain look for Maggi Aqua4 brand 10mm chain that will work as well. There might be other brands that boast higher than "standard" strengths as

on my old Super Maramu built in 1991, hull number 56 the 40 kg Rocna did not fit therefore I fit a 33 kg which worked perfectly. fair winds Robin Amel 54 #54 (2007) Carré d’As Gesendet von Yahoo

Hi Arthur, We have a 54 not SM. We ditched the original 30kg Bugel and replaced with 40kg Rocna. No change needed to bowroller on 54. Not so pretty, but now we have an anchor that works reliably for

I did put a spst switch at the fuel gauge to eliminate that draw. As well, I have made the "permanent" converters (24v/12v) switchable. I had one other mystery draw and that was high-water alarm/bilge

Thanks for sharing your thoughts. If you don't mind sharing with us what a beta60 is going to cost for the engine above earth. and what panel you chose. In your area of the world . I think many of

10. Or. 12mm. Chain? Arthur SM 435. Vista

The answer to all this is in the torque curves. As you say Danny 2800 is the max on the Amel TMD22A installation. This effectively limits its max OP to approx 60HP. I have been very happy with this

Thank you. Here in. Stockholm winter is coming. Do you use 12 or 10 mm chain ? Kind Regards Arthur SM 435. Vista

Thank you. Bill for always thinking two steps ahead. 12 or 10 mm chain??? Best Arthur SM 435, Vista

Thank you. Sounds. Good. Do you har 10 or 12 mm chain? Arthur SM 435 Vista

We also use a 40kg rocna. Flawless, we’ve never dragged once it’s set. Cheers, James. SeaBean, SM344

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Cordage types.docx Uploaded by :

I made a mock-up out of heavy cardboard using full sized drawings from Rocna before ordering. Kent Robertson S/V Kristy karkauai@... USA cell: 828-234-6819

Arthur, Everyone I know of who uses a Rocna on a Super Maramu uses a 40kg/88lb model. The next size smaller is a 33kg, which is on the small side, and the next size larger is a 55kg which is getting

Thanks Eric. I have bought another dyneema 12mm line with a more abrasive outer. I will try that but thanks for the tip. Regards Danny Sm 299 ocean pearl