I have the same speakers. Works very well Heinz SY Quetzal Supermaramu 2000 292 Am 18.12.2018 um 02:39 schrieb 'Mark Erdos' mcerdos@... [amelyachtowners] <amelyachtowners@...>:

Dear all, I’m going to install a new ICOM hf, should be a 7100 with pactor available in Italy. I will install a 7 mt antenna starboard, close to the EMEK marine solar panel arch. My question is: did

Dean, My only worry with using the engine starting battery for the Icom is the negative ground. The radio will be grounded onto the plate located by the rudder and the power to the radio at the

Hi again NIck, Where did you locate the M-802 Transceiver Unit? If somewhere around the chart table area, do you have any RF interference issues with the long signal cable run from the chart table

HI Gents, Good work, I'm happy to be added. SY Stella, Amel 54 Hull No 154, 2010 Cheers Dean

Steve, I learned alesson here with the speakers. I found some great sounding 4” DC Gold speakerswith good bass but the speaker magnets were so powerful they threw off thecompass and I sold

Steve, I learned alesson here with the speakers. I found some great sounding 4” DC Gold speakerswith good bass but the speaker magnets were so powerful they threw off thecompass and I sold them

Hi Steve, I replaced our outside speakers with a pair of low magnetic field marine speakers from Poly Planar (I think). There are lots of them out there. They don;t affect the compass at all. The

Hi, Ken. I had the same issue earlier this year. Yes, Antal changed the track size. I had to replace the track for €457. Your Mainsail is probably not set up for this, but I've seen some mainsails

Anyone have good luck replacing their cockpit speakers with a high-quality replacement? Any issue good or bad? Thanks, Steve Bode SV Intention Amel SM #117, 1994

Thanks for the info on the Andersen Line Tender, Gerhard from Sharki #60. I'll drop him a line. -Bode

Hi, Mark. So, I don't get it. What was stupid about this post that I don't understand? I need to replace my cockpit speakers as well and was just about to pull the trigger on the DC Gold 4" speakers.

Hi Everyone; I ran into this AMEL 50 build thread which I thought you may find interesting. Wishing AMEL the best in their new ventures and hoping the company can stay around for a long time.

Alan, if you send me your email privately, I'll add you as editor to the sheet (and I've got some comments to send directly to you). Mine is brentcameron61@.... Thanks.

Hi Nick, That’s great information. I’ve always hated trying to get that smoke back inside the box! There are some isolated DCDC converters available which would produce 30A each, so like your

Hi Dean, On Amelia we have the M802 SSB installed by Amel. They chose the DC converter route: there are two Mastervolt 20A converters in parallel. These are located under the chart table in the

Hi, I am planning a new installation involving an Icom M801E HF Radio (which I already have). The unit needs to be powered from 12V and the specifications call for up to 60A. (This is double the power

And one more refinement to the chain idea... In almost every rigger's tool bag you'll find a foot long piece of bicycle chain. It is usually easier to thread down the mast because it only bends in