Patrick, You'll want to re-post using the words at and dot in your email address instead of the characters as Yahoo strips those out and no one can reply to you. ---In amelyachtowners@...,

I have three bottles of AMEL wine, an un worn AMEL baseball cap, an un worn AMEL logo bath robe, plus a set of un used towels, all at the bargain price of $320,000 PLUS A 2003 SM 2000 included in that

PITU SM for sail contact information: Maria and Willy Geiger pitugolf at Hotmail.com

Hello PITU ouf Super Maramu si for sail in Tahiti. Please contact me at pitugolf@...

Thanks, Bill and Eric. I am not sure if my client's bolt at the bottom of the outhaul gearbox driveshaft was original, but his bolt does have a shoulder. It seems logical to me that you would engineer

12mm is the forestay dimension. Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School http://www.amelschool.com 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970 My Calendar

Thanks Gerhard, I think I ll order two new switches just to get the rubber caps. Nevers hurts to replace parts before they fail. Best in the New Year to you, i appreciate the help. Dave Sv

Hi Eric, Thanks for info Happy new year Ahmet 'sailormon' kimberlite@... [amelyachtowners] <amelyachtowners@...> şunları yazdı (30 Ara 2018 18:01):

As usual marine suppliers takes 4times more money than the manufacturer of the part. The Vetus price is about 40 Euro while the manufacturer takes about 10 Euro for the same piece. Gerhard Sharki #60

Thanks Peter, I will try it with tight Vectran at the end of January and report back to the group. I am fairly confident, after reading the email Mike received from Bernard, that it will be

Sorry all, I again failed to identify myself: Peter de Groot La Querida sm#207 Moss Landing CA, Yes Alan, I will repeat with some new Vectran line. It may take a few weeks before I have the

Bill, Kimberlite came with a heavy brass washer that is tapered slightly at the head of the bolt end. From memory the brass washer is about 3-4 mm thick. Fair Winds Eric Kimberlite Amel Super

Peter’s test results are certainly discouraging although not surprising. Not sure where to go from here but would be interested in any other results from others who have tried Bernard’s sheaves.

Hello "pfdg53" Your 10mm line....is it standard polyester line ? I gather it is as you say it's old and tired. Maybe it would work better with 10mm Vectran pulled really tight? Cheers and Happy New

Greetings all and best wishes for a Happy 2019, Today I went back to the boat and did a series of tests on the Bernard toe pulley installed on the starboard side and compared it to the Amel stock

We shall be putting our SM224 on the market soon in Australia. Chris

I purchased these a couple of years ago from Amel. With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising - Santa Marta, Colombia www.creampuff.us

Bill, The bolt that goes into the bottom of our main boom outhaul's Leroy-Sommers gearbox is a standard M8 hex bolt, coarse thread: 1.25 pitch. Thread length 20mm, no shoulder--fully threaded. Backed

Hello, At this time with 20/25nds wind test, it's workrs perfectly .... Note : my rope is particularly tight to avoid slipping. After trying I do not think this is a critical point

I have a prototype of Bernard thoe pulley and the first test under sail by 20/25 nds wind are perfect ... Jean Luc on CottonBay Le 28/12/2018 à 05:41, amelliahona a écrit