Hi Bill, Many thanks for that, and for fgetting me in the group so quickly! Cheers, Paul

Gary, This is a perfect way to replace the door seal/squeegee. I am very impressed! I assume the teak piece could also be machined from stainless steel, or aluminum? It seems to me that there has to

Michael, This is great information and I enjoyed the injection of humour as well! Two questions: 1. Is there room in the locker in your opinion to install a small partial bulkhead perhaps at the

Paul, Welcome to the New Group. If it is original, it is 277 bronze. Cat has rebuild kits. You may be interested in these videos: CAT Pump Maintenance -

Hi All, I think I need a new water pump for my Dessalator 100 Duo. I see it is a CAT but I cannot see anywhere that says which model it is. All I can say is that it has two pistons, and the manual I

Hi James, I consider 80m chain the minimum (which is unfortunately also the maximum for our boats unless you have your spouse playing chain rat and guiding the chain inside the locker when it is

Colin and Lauren, Thanks for your input. I am hearing nothing but great things about the Rocna and am sure that it would be a big upgrade from my current anchor. I am still not sure of which

Michael, This is great information, thanks! I am comfortable with the Med. mooring using the lazy lines but laying the anchor and backing down will be new. I currently only have 120’ of chain

Thankyou Olivier. Your explanation is abundantly clear to me and a relief to know that my practise of engaging reverse while sailing has been the right one. Cheers, Warren

Hi James, while there are some anchorages in Greece where weed can make it a bit of a problem to anchor on first attempt, there are usually enough sandy patches among the weed where you can drop your

Gerhard there is no sticker on Sea Hobo, Do I have the same gearbox as you? Can you tell from this photo? Mark Sent from my Samsung device

Same sticker here at my Sharki. I guess the bearings of the gearbox are not lubricated enough anymore when shift is in forward position while sailing. -- Gerhard Mueller Amel Sharki #60 Currently

Hello Warrren, on a Sharki with fixed prop, while sailing, you should stop the propeller by engaging reverse. This will reduce noise and packing stuff wear. There will be a "clunk" which could

Gary, I just went through the photo albums that you updated for us and it is such an improvement over the old system. Because of the organization, I was able to find many useful photos

Hi all: I just posted a series of photographs showing the replacement of my companionway door seal. I did this about 4 years ago. I have owned the boat since new and the original Amel seal began

Hello Amelians Folk on this forum have been very helpful with advice re how to remove the Maramu Genoa sheet cars. (Best bet seemed to be to undo the stanchion base fwd of the track and push this

James: I have had a Spade anchor on Liahona (Amel SM 2000) for about 8 years; I can't recall the size (weight) I bought but it is roughly the equivalent size of the SS CQG anchor the boat came new

Colin and Lauren: I know of several people who have had their chain done by Buzz Parlato of Lighthouse Marine in St. Thomas. Cell 340-334-3117, email lighthouse at islands dot vi. Evidently you

Hi Mark, the important thing is the clunk. My sign says no to forward, but as I said in my previous just to be contrary sometimes its clunk in forward, sometimes reverse. I don't think it has

Danny, The opposite istrue on Cream Puff. There is a French sticker by the throttle that says to putthe gear in forward when sailing and leave it there. We do not have a shaftbreak or alternator.