|
Re: autoprop zinc
After 15 years the main bonding in the lowest point in the black water box faille.
Then your Amel bonding system is NOT operating and the Autoprop is attacked ! his colour change
After 15 years the main bonding in the lowest point in the black water box faille.
Then your Amel bonding system is NOT operating and the Autoprop is attacked ! his colour change
|
By
jlm@jlmertz.fr
·
#46035
·
|
|
Re: Amel 54 Standing Rigging and changes to the Mainmast Lower and Intermediate Shrouds
Amelia AML 54-019 2006 has 10mm lowers and 8mm intermediaries.
This is annoying as when I bought the boat in 2017, I had all new standing rigging made.
Food for thought.....
Nick
Amelia AML 54-019 2006 has 10mm lowers and 8mm intermediaries.
This is annoying as when I bought the boat in 2017, I had all new standing rigging made.
Food for thought.....
Nick
|
By
Nick Newington
·
#46034
·
|
|
Re: Genoa Fair Leads
Hi Ken, everyone to their own. I didnt think once every 17 years too arduous to remove two screws in the stauncheon base.
Regards
Danny
SM 299
Ocean Pearl
Hi Ken, everyone to their own. I didnt think once every 17 years too arduous to remove two screws in the stauncheon base.
Regards
Danny
SM 299
Ocean Pearl
|
By
Danny and Yvonne SIMMS
·
#46033
·
|
|
Re: Genoa Fair Leads
Removing the end-stop and the stanchion each time you need to replace the sliders or the springs is a bit much. I think that removing the un-needed part of the track was the right decision. Now, I
Removing the end-stop and the stanchion each time you need to replace the sliders or the springs is a bit much. I think that removing the un-needed part of the track was the right decision. Now, I
|
By
Ken Powers SV Aquarius <ken@...>
·
#46032
·
|
|
Re: Batteries: copper bars will not work - be sure that you have jumpers to wire the pairs in series
Thanks Bill, Dan,
OK, Perigee has a copper bridging bar for each pair, running between the threaded studs of each battery in a pair.
But point taken, there may be the need to use cables to bridge
Thanks Bill, Dan,
OK, Perigee has a copper bridging bar for each pair, running between the threaded studs of each battery in a pair.
But point taken, there may be the need to use cables to bridge
|
By
David Vogel
·
#46031
·
|
|
Re: Batteries: copper bars will not work - be sure that you have jumpers to wire the pairs in series
Regarding the thread on using the copper connecting bars versus cables to connect battery pairs: I had only one copper bar, connecting one of the pairs along the front of the box (BeBe has 12
Regarding the thread on using the copper connecting bars versus cables to connect battery pairs: I had only one copper bar, connecting one of the pairs along the front of the box (BeBe has 12
|
By
Dan Carlson
·
#46030
·
|
|
Re: Batteries: copper bars will not work - be sure that you have jumpers to wire the pairs in series
I do not think the copper bars will work on all of the pairs...I just do not remember. Maybe Dan Carlson (CC'd) can answer this. They might, but you need to be prepared with jumper wires.
Best,
Bill
I do not think the copper bars will work on all of the pairs...I just do not remember. Maybe Dan Carlson (CC'd) can answer this. They might, but you need to be prepared with jumper wires.
Best,
Bill
|
By
CW Bill Rouse
·
#46029
·
|
|
Re: Batteries: copper bars will not work - be sure that you have jumpers to wire the pairs in series
Hi Bill,
.> copper bars will not work
Whoa – this is a trap for the unwary! Why is this?
We have the copper bridging bars, for use with the threaded studs with nut. Naturally enough, if we add
Hi Bill,
.> copper bars will not work
Whoa – this is a trap for the unwary! Why is this?
We have the copper bridging bars, for use with the threaded studs with nut. Naturally enough, if we add
|
By
David Vogel
·
#46028
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
Hi David & Leanne,
I want to say Hi and to put in a comment about your batteries.
Frist, I agree with Bill that you should replace the lot. Second, I suggest a different replacement. If you
Hi David & Leanne,
I want to say Hi and to put in a comment about your batteries.
Frist, I agree with Bill that you should replace the lot. Second, I suggest a different replacement. If you
|
By
Miles
·
#46027
·
|
|
Re: Furling motor brushes
Dave,
That sounds like a really good plan.
Best,
Bill Rouse
720 Winnie St.
Galveston, Texas 77550
832-380-4970
My Calendar
Yacht School
Dave,
That sounds like a really good plan.
Best,
Bill Rouse
720 Winnie St.
Galveston, Texas 77550
832-380-4970
My Calendar
Yacht School
|
By
CW Bill Rouse
·
#46026
·
|
|
Re: Furling motor brushes
Thanks Danny,
Going to order a few of the Eurton brushes and plan to modify if or more accurately when they are needed.
Appreciate the advice.
Best, Dave
Liesse SN 006
Thanks Danny,
Going to order a few of the Eurton brushes and plan to modify if or more accurately when they are needed.
Appreciate the advice.
Best, Dave
Liesse SN 006
|
By
david bruce
·
#46025
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
Mark,
Yes, I thought so to. These DEKA batteries are nothing special...they are ordinary workhorses that should give you a minimum of 3 years. Be careful because they look like Freedom batteries. They
Mark,
Yes, I thought so to. These DEKA batteries are nothing special...they are ordinary workhorses that should give you a minimum of 3 years. Be careful because they look like Freedom batteries. They
|
By
CW Bill Rouse
·
#46024
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
Hi David
We had a similar battery problem some years ago in Tahiti on our way to Fiji. I disconnected one bank which reduced our capacity but we were able to manage ok with 4 on the boat and extra
Hi David
We had a similar battery problem some years ago in Tahiti on our way to Fiji. I disconnected one bank which reduced our capacity but we were able to manage ok with 4 on the boat and extra
|
By
Alan Leslie <alanmleslie@...>
·
#46023
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
Bill,
That is adeal!!! We will probably take her up on that before we head out to the Pacific.
On another note– I heard, meaning I do not know for a fact – Batteries are very inexpensive
Bill,
That is adeal!!! We will probably take her up on that before we head out to the Pacific.
On another note– I heard, meaning I do not know for a fact – Batteries are very inexpensive
|
By
Mark Erdos
·
#46022
·
|
|
Re: Furling motor brushes
Thanks Bill.
Best regards, Dave.
Liesse SN006
Thanks Bill.
Best regards, Dave.
Liesse SN006
|
By
david bruce
·
#46021
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
David,
In Panama, you can contact Melani Beleño <compras.logistica@...> to have DEKA DC31DT lead acid batteries delivered to your boat at a dock
In April 2018 Melani wrote one of my clients the
David,
In Panama, you can contact Melani Beleño <compras.logistica@...> to have DEKA DC31DT lead acid batteries delivered to your boat at a dock
In April 2018 Melani wrote one of my clients the
|
By
CW Bill Rouse
·
#46020
·
|
|
Re: Amel 54 Standing Rigging and changes to the Mainmast Lower and Intermediate Shrouds
Thanks, Dean. As far as I know, that makes Stella #154 the earliest produced Amel 54 with 12mm lowers and 10mm Intermediates.
This is a summary of what I know as of today. I am sure the hull numbers
Thanks, Dean. As far as I know, that makes Stella #154 the earliest produced Amel 54 with 12mm lowers and 10mm Intermediates.
This is a summary of what I know as of today. I am sure the hull numbers
|
By
CW Bill Rouse
·
#46019
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
Hi Mark,
Thanks for that. Yes, it’s all in the mix at the moment.
Lithium is not in the picture, mainly because of the need to change charging and management equipment & regimes. Also, as you
Hi Mark,
Thanks for that. Yes, it’s all in the mix at the moment.
Lithium is not in the picture, mainly because of the need to change charging and management equipment & regimes. Also, as you
|
By
David Vogel
·
#46018
·
|
|
Re: Amel 54 Standing Rigging and changes to the Mainmast Lower and Intermediate Shrouds
Bill,
For your records I can confirm that A54-154 has the reinforced mast, and the up-sized rigging.
best regards,
Dean
Bill,
For your records I can confirm that A54-154 has the reinforced mast, and the up-sized rigging.
best regards,
Dean
|
By
Dean Gillies
·
#46017
·
|
|
Re: Batteries: single failed battery in the house bank, impact for other batteries
Hi David,
The biggest issue I have with specialty batteries is the fact you are getting ready to sail to areas of the world where a single replacement of a like battery would be a big issue. Should
Hi David,
The biggest issue I have with specialty batteries is the fact you are getting ready to sail to areas of the world where a single replacement of a like battery would be a big issue. Should
|
By
Mark Erdos
·
#46016
·
|