Donato, I think I fixed the link. If not, use the link in Kelly and Ryans first post that says the part number SPR-A007. -- Mark McGovern SM #440 Cara Deale, MD USA

Mark, glad this worked for you! 😀 Donato, try this: https://store.eurtonelectric.com/31x31x6brushspr-a005-1-1-1.aspx (Or try the hyperlink in my first message; that worked for me when I checked

Mark, Apparently the link you posted leads to a ‘page not found’. Would you please send it back ? Or detail the specs ? Thanks Donato SM 468 Ocean Bird

Thanks to Kent for this: Best, Bill Rouse 720 Winnie St. Galveston, Texas 77550 832-380-4970 My Calendar Yacht School

No doubt that Kelly and Ryan found something that will help many Amel owners. Good call. Best, Bill Rouse 720 Winnie St. Galveston, Texas 77550 832-380-4970 My Calendar Yacht School

I had a similar problem, the piece disintegrated. For an interim fix I used a SharkBite fitting available at any hardware store. I would not use this as a permanent replacement due to the conditions

Wery easy to do you stop the fresh air input .....:-) JLMERTZ CottonBay Le 09/06/2019 à 20:23, CW Bill Rouse a écrit : Garanti sans virus.

Thanks Kelly and Ryan for the information! These worked perfectly in our Leroy Somer MBT86M Main Furler and Outhaul motors. Our main furler stopped working under any load at the end of last season.

What is the best way to shut off a TMD22 when there is no power available to use the normal shut off method? -- Best, Bill Rouse Yacht School 720 Winnie St Galveston Island, TX 77550 +1(832)

An update on the hawse pipe replacement. After consideration of the many options and suggestions, I did a cheap and easy installation with schedule 40 PVC and standard fittings. If it doesn’t hold

Oliver I am replacing all standing rigging, including turnbuckles. They are from 2009. Regarding price, you can call Laetitia Boudon from ACMO ( laetitia@... ) and get a quote for your model and

We wanted to change the solenoid valve for the forward toilet and lost that part which is inside the plastic connector/tube. Without it water is dripping. Does anyone have an idea if there is a chance

Hello,, does anybody know how and if possible to grease the rudder hinges on an AMEL54? We are on the hard and there is grease in the hinges but do I need to fill it up somehow? Oliver from Vela

Hi kent I wish. Danny

If you provide a path, water will flow to the lowest part of the bilge. This does not have to be a limber hole though that is the fastest form of transport. ,You can use something absorbent to form

Well, that makes sense...duh? lol I guess that’s why they pay you the big bucks, eh? Kent Robertson S/V Kristy karkauai@... USA cell: 828-234-6819

Hi Kent, try healing on the opposite tack and bringing the water back to the middle. Lay some sponges there to catch it before it disappears to the other side Regards Danny SM 299 Ocean Pearl

Thanks Danny. I’ve tried that and if I twist into a pretzel and stand on my head I can get most of it on the starboard side, but not even close on the port side. Kent Robertson S/V

Hi Kent, I have a paddle wheel speed transducer that I swap for a blank when I leave the boat on the mooring to avoid it getting clogged up with marine growth. The swap always results in a few litres

Hi Danny, If it’s leaking when we set out, I fix it. If it starts leaking while on passage, (and it has done this twice in 10 years), I’ve just kept an eye on it until I get to port. Both times