Hi all: I have painted my deck stripes twice before. Both times I used Interlux Brightside single part paint. It looked good for 3 years then looked marginal for 2 years before requiring repainting

I just replaced that bushing on la Querida SM207 last week. After replacing the fixed 19" prop with the original Autoprop (that the previous owner had removed) I found the vibration had increased.

Hi Duane, where are you now? There’s a good guy in Annapolis area who was recommended by Coastal Climate Control. He works on Climma, Frigoboat, and Espar and.... His name is Mike Coleman, (443)

Hi Bill, You assumptions are only half correct. My mizzen has the same dark material underneath. The main has the lighter material. This was replaced at the time I purchased the boat. Amel Martinique

What is the material Amel used on a Super Maramu mast bases and where can it be purchased? Apparently it is a different material installed on 54s and later because the material used on later model

Alan, Symptons: When I turn the dial to ventilate, or one of the heat settings, the green indicator light in the dial comes on, but nothing else happens. No heat, no fan. The boatyard I was in

I examined them closely and did notice some changes between the old and the new. They may have improved the robustness as the old one did like to fail. Mine were both broken. Be aware the new furlers

Thanks Bill, I am pretty sure all is fine but next time I haul I will double check for any play beyond 8-10mm laterally. Nick

Nick, same as SM. There is a rubber bushing sleeved around that bolt. This is exactly what I am talking about.

Jose, Very cool! I guess I haveone more question. Where did you buy this and do you have part number? (thatmight be two questions) With bestregards, Mark Skipper Sailing Vessel-

Did you have to modify the ballooner and add a gaiter? NO Where do you attach it to on the foredeck? Directly to the anchor support plate standard hole

Thank you Bill, I will check this point at first, Jean Luc MERTZ On CottonBay Le 21/06/2019 à 15:34, CW Bill Rouse a écrit : Garanti sans virus.

Thank you for the tip I will check it Merci Beaucoup Jean Luc MERTZ On CottonBay Garanti sans virus. www.avast.com

Yes they do and the mechanical gay was experiment with AMEL SM Merci JLMERTZ Le 21/06/2019 à 10:52, eric freedman a écrit : Garanti sans virus.

Yes they do and the mechanical gay was experiment with AMEL SM Merci JLMERTZ Le 21/06/2019 à 10:52, eric freedman a écrit : Garanti sans virus.

Super Nick, It is exactly my conclusion bat the two fixed prop are perfect, so I could not image it could be possible ... Before to turn back to Autoprop (actually as spare) I will

Hi Bill, On the 54 there is a bolt covered in black mastic from the bottom of the C drive to the iron keel. Presumably this anchors the C drive. Is there any adjustments or anything to look out

On a C-Drives older than 1999, don't forget to check the C-Drive foot for side-to-side movement by pushing on the aft end of the foot. No more than 8-10mm. If you have more, remove the foot bolt to

Hi Duane, what were your symptoms? How long does it run on heat mode? Does the thermostat shut it down when it's warm? Mine runs for about 7 mins just fine then stops. It has done this for a while but

The old E14 will work fine. Jeff s/v Spirit Amel 54 #14