Hi Mark, We didn't get down to Vista Mar Marina, and heard a few good things about it. The downside was the distance from the city. Not sure that is an issue for you, but it was for my

Eric, thanks, It turned out to become a problem here in Faro, Portugal. JIC looks like its not so available in europe? Oliver from Vela Nautica A54#39 Faro, Portugal Sent from my Huawei Mobile

Thanks, the info about high pressure fittings helped to locate the type. In the end I ordered from Dessalator bcs of time issues. But the original fittings on my D100 duo are worst. The are 316

Here is the solution on Lady Annila Hälsningar/Regards Ann-Sofie S/Y Lady Annila, SM232, 1998 Skickat från min iPhone 1 aug. 2019 kl. 04:35 skrev James Cromie via Groups.Io <jamescromie@...>:

Kent - yes! Please post photos. I am also seeking a new design for replacing our bimini. Best, James

Mike, After considering a plan similar to yours, we just replaced the old cockpit enclosure with a semi-permanent fabric Bimini-like top raised a few inches above the dodger. It’s attached to the

We are about to have a new Bimini made and would like to incorporate into it a zip open panel above the Helmsman’s seat so he can stand and poke his head above the Bimini for better visibility

Ken, Can you recommend any specific spots? We are looking to spend a little time going between the marina and the Pearls. We are currently in Vista Mar Marina. It is just about 50 miles west of the

You will have fun finding a replacement. There are a few that you may be able to find with the same size. I saw this at some point: Bosch WLT24440 and/or Siemens

Hi Lior, Good deal and congrats on the easy fix!

Oliver, you can get the JIC fittings at any good hydraulic shop. Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Gary, Automotive solenoids are not usually isolated ground solenoids. I would check it. Automotive solenoids usually have the negative side connected internally to the mounting ears. If this is

I thought the Pearl Islands was a much better cruising ground than the San Blas Islands. The big problem is that cruisers don't have a nice and cheap marina like Shelter Bay on the South side of

Yes, the Dessalator High pressure fittings are "3/8 inch JIC stainless steel fittings". JIC fittings are a type of flare fitting which is machined with a 37-degree flare seating surface. Best, CW

Hi All, I ran into same problem and the hose from high pressure pump came off before i could change my hoses. Does anybody know how these terminals are caled? What kind of connector is that? Since

Hello Lior, We have an SM but changed from the small size units the SM’s were fitted with to the “Euro standard sized Siemens IQ500.” It is a washer/dryer; we rarely use the drier function but

Similar scenario while we were underway. I managed to get that DC motor free and on to the cockpit floor. There were four little hard rubber covers that held the brushes in place and when I pried

Glad to hear that fixed your problem. It is awesome when the fix is a simple one. Chuck on S/V Joy taught me about the adjustment pot on the rear side of the control panel. All the Best, Paul

well, I have SHARONA since 7 year and never used the dryer. Now we are in Montenegro and it is first time that we had (in spring) many rainy days and everything was wet for days... in such a case it

You don’t need the dryer. Your laundry drues faster outside in the wind, and the do the ironing for you as well. Hälsningar/regards Ann-Sofie Svanberg S/Y Lady Annila SM232, 1998 Skickat från min