My Amel just took us here, right now! What an amazing adventure machine! And I just raced my buddy from Raiatea in his new Leopard 48. It blows his mind that a monohull is faster than his cat! Bora

We’re all aware of the definition of “Cruising”. It applies to Amels and ALL boats! ~~~⛵️~~~Matt

Bernard , On my Volvo TMD22a the heat exchanger has a rubber cap on each end, the caps seal around the heat exchanger tube and also seals around the heat exchanger vessel or housing that contains the

Bill , Great to read . The Amel yachts and the Amel understanding of cruising at sea add up to something extraordinary which enriches the lives of everyone who owns or aspires to own an Amel. We do

All owners and all non-owners interested in the Amel Brand: In the month of July, we added 31 new members to the Amel Yacht Owners Group. There were 20 new members who were "Interested in buying an

Bernd, So sorry, Iread your problem too quickly and thought you were losing coolant. I justre-read and see it is becoming contaminated with saltwater. You are in theright area. Keep hunting about

2 answers at once. 1st pressure check done with a compressor. Meaning compressor to one side of the pipes and sealed on the other side. 2nd Will reinstall tomorrow. Seals seem to be good, will check

Did you install a hardtop? With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K - #275 Currentlycruising - Vista Mar, Panama www.creampuff.us

Brend, As others havealready suggested, the heat exchanger is the most likely culprit. You have ahole somewhere. Either in a seal or a failure in the exchanger itself. Thiswould be your best case

Hi Bernd, It will be a seal that separates the two water streams. The TMD 22 volvos and different heat exchangers on different engines so cant be definitive but investigate all the

Bernd, Seawater should only come in close proximity to coolant (sweat water) inside the heat exchanger. There has to be a leak in there somewhere. How did you conduct the pressure test? -- Mark

We replaced the original Bosch machine in 2017 when it started to trip the power out. The replacement was as in the previous post, a Beko. There are very few half depth machines available and Bosch no

Hi everyone! Following problem on a SN (119 From 1995) Engine VP MD22 L I have the following problem... After a few hours engine ops the sweat water (coolant circuit) becomes saltwater. I suspected

Check eBay also ~~~⛵️~~~Matt

This is the model of the 54 OEM clothes washer: BOSCH WLX24460FFHeight:85.6cm / Width:59.5cm / Depth:44.1cm This is the model of the Beko possible replacement clothes washer: BEKO WMS6100Height:

I have purchased an ST60 online through eBay last year at a low cost as works fine, good luck

I replaced my washing machine with a Beko 6kg 1000rpm one that I found in Spain. It barely fits, but the nice thing is that it's 50% more capacity than the original Bosch. Securing it was a pain but

Just to clarify the tridata instrument works when powered up, its just causing problems with the seatalk bus. Also I am not asking for a freebee, just would rather purchase one from this family than a

Hello all, my ST 60 Tridata Raymarine instrument finally stopped working on the SeaTalk bus. Worked with Raymarine and did the troubleshooting and they said the unit was bad. So I can replace with

Mike we have donned that search Kerpa in the photo section, we have had it for three years now and still very happy with it. It was a great improvement towards the original. Paul SY Kerpa SM 259