Right, thanks Bill. There was no washer, just the O Ring seal. I’ll take it up with Amel. Cheers Dean

Hi Dean, Slightly off topic, where are you hauled out in Scotland? Masts down? It will be pretty windy in that part of the world over the winter months. Nick

You may be missing the washer which should have been supplied by Amel. This washer and the O ring seal the V bolt. Best, CW Bill Rouse Amel Yacht Owners School - www.YachtSchool.us 720 Winnie

Hi folks, We are on the hard stand and I started the job of replacing the C-Drive lower seals since my C-Drive oil has gone a little like a chocolate milkshake. When we came ashore, I noticed a

Mike, No problem. JL Mertz's Speedi-Sleeve idea is a good one too as the surface finish on the shaft is really not good enough to ensure a good seal with the oil seal. Regarding the Annapolis Boat

Hi Ian, If you speech of the Speedisleeve flag, NO I reduce the seize of the shaft with sand paper to have the exactly same diameter of the inner size of the seals, and ad a lithe

With regard to the brown wire and a Mastervolt Alpha Pro regulator: the On/Off control of the regulator _is_ the brown wire. In fact, if the brown wire is not interrupted at installation time via an

Hi J.... When you fitted the Speedisleeve did you remove the flange ? Ian and Judy, Pen Azen, SM 302 Greece

Hi Scott Thank you again for sharing all this information and it certainly helps my awareness and thoughts moving forward As you know the previous owner of my A55 upgraded the system to almost a

Thanks very much, Scott. Excellent write-up. I have a few questions and comments. 1. The A55 comes with a switch that in the "on" position, turns on the generator automatically if the SOC goes

My pleasure James! It always makes me very happy knowing my site is being used. I hope it is all clear on the illustration. From memory the perpendicular plank of the battery compartment cover is

Thank you Alex. Actually, my battery compartment accommodates only 8+1. I should have thought to check your comprehensive website before posting! I’ve accessed your web pages many times as I

Hello James, Here are the dimension for the 8 + 1 battery configuration. http://www.nikimat.com/battery_compartment_space.html But I suspect your hull number has the 12 + 1 batteries. Sincerely,

To Amel Super Maramu owners: I am looking to replace my house batteries, and would like to ask if anyone can share with me the dimensions of the battery compartment, as I am not on our boat

Hello Mark, I used 10 years ago SKF Speedi-Sleeve, I posted photos ... it is wonderful .... never change it ! ....I can recommand you this JL Mertz

Mark, indeed there were some scratches on the plastic shaft. Will gently sand them out, measure, and go with the 29mm seal. Thanks for the insight! Seems like a Amel mini-rendezvous may be

Fantastic write up Scott. I kept writing down questions and then erasing them as I read further and you answered them. I’d love to see a schematic at one point but I think most of it is pretty

Hi Scott, Very interesting to read about your project. You have obviously enjoyed the whole process and the challenge. Would it be impertinent to ask how much it all cost? I will stick with my

An excellent write up Scott and very useful. We have had a Victron Quattro 5000/120 since 2013 and have been very pleased with this. It is clear that lithium is the next step.

Rob, Does the Victron Isolation Transformer take 60hz input and output 50hz? -- Scott 2007 A54 #69 SV Tengah http://www.svtengah.com