Hello Karen, that would be awesome. We are in Port Canaveral but will ping you our next trip to Lighthouse Point. How long will you be in Fort lauderdale? Really appreciate the offer. I can also order

Thanks Tom Very helpful Andre

Have you considered checking your hot water immersion tank? I had the same problem on Pure Magic when we owned her and found that the thermostat had failed. Once replaced, the problem was solved.

Thanks perfect

Hi Andre, Not sure about dimensions on the Mango, it worked well on my SM. Check your holes and clearance above the sink. I used "Comllen Commercial Stainless Steel Single Handle Pull Out Kitchen

These pictures should explain:

Tom Can you share the type and model of the new faucet you installed and where you sourced it? Thank you Andre Kaplan Renaissance 2000 Mango 71,1988 Westbrook, CT

Hello Michael, Thank you for the idea. I'll leave in line for another possible solution. I checked the two hoses on the outside of the boiler and both are very hot - that means hot water is all over

You can install a thermo mixing valve on the outlet of the water heater. This will limit the temperature to 50 to 60 Celsius in the hot side. Michael nebo sm251 Sent from Yahoo7 Mail on Android

Hello guys, Thanks for the feedback again, Following Newington's reasoning, I think installing the check valve could solve the consequence, but not the cause of the problem. I'll probably do it if

Hello Olaf, I have a Santorin, the built is very similar, I would send the pictures to SAV Amel for comments. In my case I had similar cracks along the rudder shaft and after consulting Amel was told

Hello AMELians, does anyone have experiences with removing the rudder on a SM2K and could provide the steps (a how to) and what I have to consider while de-installing the rudder? It seems that the

Arno could you be more clear about the stanchion I am not sure where it is thanks Courtney sv Trippin 54 #101

The keys are “Y2” and weren’t easy to find, but Amazon has them! If you’re in the Fort Lauderdale area I have some extras you could have! Karen Smith S/v Harmonie , Fort Lauderdale

Thanks for those insights Andre

One last idea, regardless: If you have the original Amel faucet mechanism (which I assume is similar to that on our boat), I would replace it no matter what the problem turns out to be. Our faucet was

I suggest you install check valves (one way valve) on the cold side before the mixer tap. This will prevent hot water working it’s way into the cold side. It is a common problem especially when

Guys, Thanks for your advices. I'm living on board the boat in Alicante - Spain. Cheers Jose Prieto SY Wayag SM323

-- Gerhard Mueller Amel Sharki #60 Currently Kalamata, Greece

My Sharki from 1982 has a sticker near the gear shift level saying not to have the level in forward position and engine off while sailing. Using the propshaft alternator the level must be in neutral