|
Re: SM galley Faucet very hot.
Hi Andre,
Not sure about dimensions on the Mango, it worked well on my SM. Check your holes and clearance above the sink.
I used "Comllen Commercial Stainless Steel Single Handle Pull Out Kitchen
Hi Andre,
Not sure about dimensions on the Mango, it worked well on my SM. Check your holes and clearance above the sink.
I used "Comllen Commercial Stainless Steel Single Handle Pull Out Kitchen
|
By
Thomas Peacock
·
#49746
·
|
|
Re: Warning about the foot of middle (removable) stanchion of lifeline/railing at the stern (Amel 54)
These pictures should explain:
These pictures should explain:
|
By
Arno Luijten
·
#49745
·
|
|
Re: SM galley Faucet very hot.
Tom
Can you share the type and model of the new faucet you installed and where you sourced it?
Thank you
Andre Kaplan
Renaissance 2000
Mango 71,1988
Westbrook, CT
Tom
Can you share the type and model of the new faucet you installed and where you sourced it?
Thank you
Andre Kaplan
Renaissance 2000
Mango 71,1988
Westbrook, CT
|
By
Kaplan,Andre
·
#49744
·
|
|
Re: SM galley Faucet very hot.
Hello Michael, Thank you for the idea.
I'll leave in line for another possible solution.
I checked the two hoses on the outside of the boiler and both are very hot - that means hot water is all over
Hello Michael, Thank you for the idea.
I'll leave in line for another possible solution.
I checked the two hoses on the outside of the boiler and both are very hot - that means hot water is all over
|
By
JOSE PRIETO
·
#49743
·
|
|
Re: SM galley Faucet very hot.
You can install a thermo mixing valve on the outlet of the water heater. This will limit the temperature to 50 to 60 Celsius in the hot side.
Michael nebo sm251
Sent from Yahoo7 Mail on Android
You can install a thermo mixing valve on the outlet of the water heater. This will limit the temperature to 50 to 60 Celsius in the hot side.
Michael nebo sm251
Sent from Yahoo7 Mail on Android
|
By
michael winand
·
#49742
·
|
|
Re: SM galley Faucet very hot.
Hello guys,
Thanks for the feedback again,
Following Newington's reasoning, I think installing the check valve could solve the consequence, but not the cause of the problem. I'll probably do it if
Hello guys,
Thanks for the feedback again,
Following Newington's reasoning, I think installing the check valve could solve the consequence, but not the cause of the problem. I'll probably do it if
|
By
JOSE PRIETO
·
#49741
·
Edited
|
|
Re: removing the rudder on a SM2K
Hello Olaf, I have a Santorin, the built is very similar, I would send the pictures to SAV Amel for comments. In my case I had similar cracks along the rudder shaft and after consulting Amel was told
Hello Olaf, I have a Santorin, the built is very similar, I would send the pictures to SAV Amel for comments. In my case I had similar cracks along the rudder shaft and after consulting Amel was told
|
By
Jean-Pierre Massicotte
·
#49740
·
|
|
removing the rudder on a SM2K
Hello AMELians,
does anyone have experiences with removing the rudder on a SM2K and could provide the steps (a how to) and what I have to consider while de-installing the rudder?
It seems that the
Hello AMELians,
does anyone have experiences with removing the rudder on a SM2K and could provide the steps (a how to) and what I have to consider while de-installing the rudder?
It seems that the
|
By
Olaf Bauer
·
#49739
·
|
|
Re: Warning about the foot of middle (removable) stanchion of lifeline/railing at the stern (Amel 54)
Arno
could you be more clear about the stanchion I am not sure where it is
thanks
Courtney
sv Trippin
54 #101
Arno
could you be more clear about the stanchion I am not sure where it is
thanks
Courtney
sv Trippin
54 #101
|
By
Courtney Gorman
·
#49738
·
|
|
Re: New companionway lock source
The keys are “Y2” and weren’t easy to find, but Amazon has them! If you’re in the Fort Lauderdale area I have some extras you could have!
Karen Smith
S/v Harmonie , Fort Lauderdale
The keys are “Y2” and weren’t easy to find, but Amazon has them! If you’re in the Fort Lauderdale area I have some extras you could have!
Karen Smith
S/v Harmonie , Fort Lauderdale
|
By
Karen Smith
·
#49737
·
|
|
Re: Propshaft alternator on 1985 Mango
Thanks for those insights
Andre
Thanks for those insights
Andre
|
By
Kaplan,Andre
·
#49736
·
|
|
Re: SM galley Faucet very hot.
One last idea, regardless:
If you have the original Amel faucet mechanism (which I assume is similar to that on our boat), I would replace it no matter what the problem turns out to be. Our faucet was
One last idea, regardless:
If you have the original Amel faucet mechanism (which I assume is similar to that on our boat), I would replace it no matter what the problem turns out to be. Our faucet was
|
By
Thomas Peacock
·
#49735
·
|
|
Re: SM galley Faucet very hot.
I suggest you install check valves (one way valve) on the cold side before the mixer tap. This will prevent hot water working it’s way into the cold side.
It is a common problem especially when
I suggest you install check valves (one way valve) on the cold side before the mixer tap. This will prevent hot water working it’s way into the cold side.
It is a common problem especially when
|
By
ngtnewington Newington
·
#49734
·
|
|
Re: SM galley Faucet very hot.
Guys,
Thanks for your advices.
I'm living on board the boat in Alicante - Spain.
Cheers
Jose Prieto SY Wayag SM323
Guys,
Thanks for your advices.
I'm living on board the boat in Alicante - Spain.
Cheers
Jose Prieto SY Wayag SM323
|
By
JOSE PRIETO
·
#49733
·
Edited
|
|
Re: Propshaft alternator on 1985 Mango
--
Gerhard Mueller
Amel Sharki #60
Currently Kalamata, Greece
--
Gerhard Mueller
Amel Sharki #60
Currently Kalamata, Greece
|
By
Gerhard Mueller
·
#49732
·
|
|
Re: Propshaft alternator on 1985 Mango
My Sharki from 1982 has a sticker near the gear shift level saying not to have the level in forward position and engine off while sailing.
Using the propshaft alternator the level must be in neutral
My Sharki from 1982 has a sticker near the gear shift level saying not to have the level in forward position and engine off while sailing.
Using the propshaft alternator the level must be in neutral
|
By
Gerhard Mueller
·
#49731
·
|
|
Re: New companionway lock source
Hi JP. You will need to take your key to mobile locksmith kaitaia.
Regards
Danny
Hi JP. You will need to take your key to mobile locksmith kaitaia.
Regards
Danny
|
By
Danny and Yvonne SIMMS
·
#49730
·
|
|
Re: SM galley Faucet very hot.
Hi Brent,
How did your last Amel trip go? I think I am right aren't I?
Rgds
Richard
Hi Brent,
How did your last Amel trip go? I think I am right aren't I?
Rgds
Richard
|
By
Richard Colebatch
·
#49729
·
|
|
Re: SM galley Faucet very hot.
I had a very similar situation to that one time in my house…. I woke up one morning to find that the water in the toilet bowl was steaming! Thankfully, I realized it before splashing myself. It
I had a very similar situation to that one time in my house…. I woke up one morning to find that the water in the toilet bowl was steaming! Thankfully, I realized it before splashing myself. It
|
By
Brent Cameron
·
#49728
·
|
|
Re: New companionway lock source
Hey Danny,
Happy New Year.
Good to know regarding key blanks; I need 2 more keys
JPG
Jean-Pierre Germain
jp.germain45@...
Hey Danny,
Happy New Year.
Good to know regarding key blanks; I need 2 more keys
JPG
Jean-Pierre Germain
jp.germain45@...
|
By
Germain Jean-Pierre
·
#49727
·
|