I just changed the timing belt and thought I would provide information to others with the same engine. -- Mark Mueller Brass Ring A54

Thanks for the immediate response. I wrote to AMEL Mediterranee last spring; the response was that this tool was no more available and I thought that was definitely so. May be I try again with AMEL

Hello, Amel Club, I want to replace the Espar heater exhaust hose on my 1989 Maramu #258. The Espar was installed by Amel as original equipment. The braided metal exhaust pipe goes into a metal pipe

Hello, The pump interface E51385 is also available from http://www.penguinfrigo.co.uk/ https://penguinfrigo.co.uk/product/12-volt-or-24-volt-pump-interface/ Best Soraya GARULFO A54-122

One of my clients told me that he bought the tool from SAV"at"Amel.fr within the last 60 days. Have you actually written Amel? If so, what was their response? --

Dear Amelians, I just wrote one or two times before now, but I religiously read all your very interesting interventions. My husband and I are preparing our Santorin for the Atlantic crossing in

Thanks Heinz!!! Wearing the shirt you gave me at the moment!!! Here is the exact link: Bow Thruster overhaul Nikimat Sailing Vessel Amel Super Maramu 2000 Bow Thruster overhaul Nikimat Sailing Vessel

Go to. Nikimat.com. Alexander did make a very good side with fotos. Fair Winds HEINZ SY quetzal sm2000, 292

These set screws are a common size and can be purchased at any shop that sells bolts, nuts, and screws. --

Thanks Bill the screws are missing. -- Bernd SN 119 / Cascais, Portugal

Bernd, Here is part of the page from my book: -- CW Bill

Hi, I just prepared erverything to service the bowthruster on my SN. Now I have connected the special tool to lower it in the water but.... how do I secure the special tool??? I only have the tool but

Thanks Alan and Mike, Looks like Annie is slightly different that #23 and #437 in that there was no eye bolt and the stud is threaded on the top, with no bolt head. Maybe previous owner

Eye bolt is to connect the preventer. Best, CW Bill Rouse Amel Owners Yacht School - www.AmelOwnersYachtSchool.com 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

Barry, They used my old ones as template for the new ones, and made them identical in every respect, holes, grooves etc, except for the very slight curve but that has not been a problem and I’m

Hi Paul, Thank you for this contact, we have just arrived in Barbados and will be going to Grenada sometime soon. I am looking to get mine replaced after some acid type liquid was dropped over mine

Hi John, If yours is like ours, which I'm sure it probably is, the bolt, in our case an eye bolt, passes through the track and is threaded into the steel plate which is under the gunwale. I broke one

Hi John, I think our genoa track set ups are similar but perhaps yours has been modified or repaired here? I haven't taken on this project yet but it's on my list. Looking at mine, it looks like a

Congrats Jer! We replaced our old galley fridge last year with an Isotherm CR130EL sourced from Marine Warehouse (we were in Panama at the time but I think they are Florida based). It was a good fit

Hi All, I have finally gotten around to replacing the genoa sheet cars and have hit some unanticipated trouble. Thanks to the Forum I was well prepared for releasing the rail stanchon which went