Hi Dan We have an identical bracket on Ocean Pearl. I always thought it was an Amel standard fixture. Regards Danny SM 299 Ocean Pearl

Courtney, here are some more photos of the engine bracket. I have seen it on other Amels. The wood is a real Marine laminate. There are two SS straps that giver the top rail and hold it all

Good afternoon Randall, Thank you so much, I am very flattered and extremely honored by your message. Today being my birthday, it is one of the nicest message I could receive. Sincerely,

Scott, I reread your message and saw you have your panels in parallel - do you have blocking diodes at each panel? These would be necessary to prevent current in your open-circuit situation. If you

Hi Scott, open circuiting the panels, as you said, means no current and no hotspots/damage. just wanted to clarify, the switches are between the panels and charge controllers, NOT between the

Dear Carina, Also use additive in my fuel – don’t have (much) soot at all but that might be bcoz I have the D3 H version which apparently runs more efficient than the D3 C. The soot I do have

Scott, I have the antenna on starboard side of solar arch. The NEW ZEALAND marine electrician ran the cable thru the starboard conduit to the nav station. Unit is in a IRIDIUM GO bracket at the

Thanks Karen. Consider me interested, and let me know how things progress. Steve Aloha SM 72 Hawaii

Hi Dan would you mind sending me a picture of your outboard I like the way it is secured also did you add any reinforcement to the board it is attached to? Cheers Courtney Trippin

Hi Alan, Thanks for the reply. Agree that NEW CALEDONIA is NO problem at all. I sailed for about 18 months around NC (still own a mooring there😊); during 2018 had a bunch of AMEL parts come

Tom Peacock SM Aletes #240 Carriacou

I mounted ours in a corner under the hard dodger. The little bit of fiberglass does not seem to interfere with reception.

Hi Scott, here is a picture of my antenna mount, the wire pass thru the deck with compression fitting, and the inside mount by the nav station. I used an existing hole in edge of the deck. I also

I use “Black Streak Remover”. Takes it right off with just a bit of hand-polishing. It works great. There are several brands available; I’ll be aboard on Saturday and will reply further with

I know it has been done by many on this forum. Can you please chime in on what it cost to have your headliners professionally replaced. thank you Chip

Alexandre, Nikimat was one of my inspirations for buying into the AMEL world. I remember seeing it after the Hurricane in a you tube video it was sad to see. I have wondered what became of her. Take

Bob, Removal of the wood panels was one of my concerns as well. Fortunately there was some relatively recent discussion on the boards that indicated that the panels are fastened in with the bolts

Hi all, We just scored a great deal on a used Iridium Go with the external antenna. It comes with 12m of antenna cable and the mount for steel tubes.

Like Peter, I have zero black soot on my A54. -- Scott 2007 A54 #69 SV Tengah http://www.svtengah.com

All, We are scheduled to transit the Panama Canal today and I'm trying to be extra careful with respect to covering the panels to avoid damage by the monkey fists thrown by the canal advisors. Our