I don't think you are an idiot, but I KNOW YOU ARE VERY FUNNY!😀

Oooo, Doug reminded me of something (you might like this too, doug).... Our SM aft cabin was modified brilliantly into a wall-to-wall bed. It has some custom foam inserts around the four sides about

Oliver, I am 6’6”, so I guess that equals about 1,95m. And I was equally concerned about this. The areas you mention are not a concern. The boom is not really a factor in the cockpit on the

Could you insert and glue a dowel into the broken ends? Kent SM 243 Kristy Hi I bent the water level dipstick with 900 liters in the tank, so near the bottom of the dipstick. (I was running the

I figured I was an idiot, and it turns out I was correct :)

Hey Oliver! Good call on looking at Amels, for hundreds of reasons. Headroom is defo one of them... I just measured for ya, our SM has 208 cm in the galley and saloon, and 200 cm in the head and

Hi Amel owners, I'm in the early phase of buying a boat on which my wife and I will spend up to 5 years, maybe more. Due to my body height of 2,02 metres (6"8), I have some special requirements

Yes, that breaker is for the 24 volt windlass and genoa furler. Maybe your meter is set wrong or you didn't use the 24 volt negative. Check again. Best, CW Bill Rouse Amel Owners Yacht School +1

Hello Ryan and Kelly, I refurbished my original turning blocks by replacing both the needle bearings and the race bearings. Works like new. These were sourced in NZ and total. Cost was less than

Hey all, so thanks to Bill's advice to remove the whole panel via the knob (which I really should have noticed but there were clothes packed into the second-most forward cubby), I yanked it and

Hi Ryan, I recently replaced my genoa blocks with new Antal blocks supplied by Euro Marine. The blocks that came with our boats are now out of production. I'm attaching a picture of the blocks I

If you have an older SM I recommend you take a hard look at the Genoa sheet cars. I had one fail in light wind. Bill Kinney had similar failure mode. 20/30 year old gear. I got my new ones from

Hi I bent the water level dipstick with 900 liters in the tank, so near the bottom of the dipstick. (I was running the watermaker, stumbled going down the companionway and grabbed anything.) It is

Hi, I made this piece 2 years ago for a client, it s easy to made. If you need it look for someone with a milling machine and lathe and it can be easly done. you can see the problems he had here

Rig Rite might also have the blocks, They are up in Rhode island. https://rigrite.com/Spars/SparParts/Sheaves.php. Fair Winds Eric Amel Super Maramu #376

HI, When you eventually get the thruster apart,. I would suggest you take the motor to a rebuild shop. . There is an open roller bearing at the bottom of the motor where the tube enters the motor. I

Hi Mike, Thank you very much for the info. We might want to replace our cars soon, but what we're looking for right now are the blocks (pulleys) that are at the aft ends of the tracks. Ryan and

Hi Ryan, We replaced our cars in 2016, exactly as original as custom made for Amel by Antal Italy. US distributor Euro Marine Trading in Newport, RI. Very good to work with. Hope they are still

Hi Ellen, In addition to what you're doing and Bill Rouse's suggestions (sans Amel tool) I was finally successful by using a chain wrench around the motor flange along with a 2' extension pipe for

Hi Ellen, There might be another way, but you will need a lot of time energy and patience. The bow thruster on my SM jammed solid a few years ago in Mexico and it would not move. After