Mohammad, It was at a time when the HP pump was on its way out. I ended up replacing it. I have since run with the pressure on the orange/green border and it has been fine and still made 100+

Hi Mark; Some potential causes that maybe worth looking at and a couple of questions; How many hours do you put on your membranes before they need replacing? Any potential source of chlorine in

Alexander, Take the prop to a place that has a soda blaster. It'll cost a minimal amount and can be done while you wait. With best regards, Mark Skipper Sailing Vessel - Cream Puff - SM2K -

Miles, So good to hear from you and hope you are doing well. Thanks for the info on the chlorine test strips. This is an avenueto pursue. We do see lower ppms when we run the water-maker for

Mohammad and Aty Thanks, I had basicallyfound the same things in researching this. However, something is amiss since weare using membranes at a rate much greater than others. With

Thanks Danny, When flushing.I have not opened the pressure valve. Perhaps this is the issue. The usermanual on this for the D60 is very vague. With bestregards, Mark

Ken, We do not havea pre-pump. I was unaware of the air issue. For the most part I do not see airin the system (via the float gauge). Once and a while there is air during thestart up if the

My only thought is like others, make certain that there is no chlorine. Obviously, there shouldn’t be if all you do is make RO water. Do you ever put water in the tank from the marina? We often have

As it has been said earlier in this post hydrocarbons (oil, fuel, etc.), chlorine, and over pressure are by far the biggest killers of RO membranes. Operationally, never exceeding the rated capacity

Hi Paul; Was there a specific issue that you were dealing with that led Martin to give you that advice? Happy Sailing; Mohammad and Aty B&B Kokomo AMEL 54 #099

Covid- project - getting replacement prop to shine again... Using grandmothers old recipe (toothpaste) and it takes its time... any better ideas around? Best Alexander SY Antinea SM #231

The original posting has nothing to do with Amel Yachts. I am locking this message topic. As a reminder: We encourage postings which will genuinely help Amel owners source needed parts and services.

Hi Bill I am also interested. Topic for me could be: changing the old B&G network to NME2000 and current systems. Best regards Rink Amel SM2k #330 Razors Edge

Very interested. The two topics? 1- how to fix, repair or replace info for everything. 2- where to source any relevant parts. I know were surrounded by knowledge and good people. So many have

Sounds like a Political conspiracy Is this the purpose of Amel Owners forum?

This video interview answers the question, What in this world is really going on? A famous doctor answers this on a little known channel, because it is against the mainstream. Please watch and share

Thanks Bill Agree and interested Martin Hameline VoileOVent Maramu

Thanks Bill will be of course a nice initiative to meet the Amel community. cheers Marco Mancini SM Desiree 304

Hi Mark, I once ruined a set of membranes by putting chlorinated dock water in the boat and then back flushing. Since then any shore water that goes into the boat first goes through a “whole

We would definitely be interested in this as new Santorin owners since December. We have much to learn. Tony Wetmore Notorious