If you're leaking product then it's a low pressure line that is leaking. I would start at the product end of the tubes and it shouldn't be too tough to find the leak. Follow all the lines until they

Hello Kevin, I am very happy with the WakeSpeed 500. Here is a photo of my install. I attached a plywood mounting board to the aft bulkhead of the engine room, behind the engine/alternator. (With

Thanks John Yes Electec is a good company. I will go tomorrow to speak with them about the end caps from DesalI. I have still 6 end caps, 2 of them with the hp water inlet, from Desal, He sended to me

Hi All, the mild steel that supports the gas struts in my engine room hatch has gotten water into it and is rusting away and expanding causing a bulge in the engine room hatch in 2 spots. Has anyone

Hi Alin, This might be useful: https://youtu.be/wTa6HEo2_K8?t=345 Delos is testing new panels on their top to compare to their arch mounted. They’re mounting flexible panels in

We have 2x180 watt 72 cells on the rail works great, in addition to that I ordered two custom made 180 w 72 cells flexible panels from Hovall (china) for my bimini (not arrived yet). The advantage

I bought 1kg of Sodium Metabisulphite from www.westwatermakers.com (UK) for £23. Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

Hi Alin, See enclosed pdf with pictures : 4 Suntech STP190 1580 × 808 × 35mm 72 cell panels above the cockpit, 2 series 2 parallel. The challenges: * Max. regulated output is 10A at 24V: not

Wow to what Eric was relating.... but that sort of bring up my point: I haven't been even remotely tested in this boat in horrific conditions, but from everything I read and hear (including just now

Alin, Here’s a sitewith a couple of ideas: https://www.emarineinc.com/categories/Solar-Kits With bestregards, Mark Skipper Sailing Vessel- Cream Puff - SM2K -

Hi Alin, At present I am studying how to adapt SolarFace by Tecnalia in my Sharki, Acrobat II, I did it in my Acrobat I (Sigma 38 OOD) before, and these protypes have been working perfectly since I

Hi Alin; We have also looked for a while for a solution that does not include the Arch. We also intend on switching to Lithium batteries when our current Gel setup needs replacing in 2-3 years.

Hi Danny. Thank you, I'd love to have a look. Cheers Alin

Hi Alin, the best spot for two panels is on the port rail aft of the cockpit. I put mine there temporarily 11 years ago deciding to move them later if I didn't like the spot. Been fantastic Clamped

Hi guys. I know this subject must have been discussed before, I do not mind if you point me out to the right direction. Anyway, I am seriously thinking solar panels for my Super Maramu. The goal is to

Dan, I'm planning to install the Wakespeed WS500 on Rascal. We have the Leece Neville 175A alternator and AGM batteries, and this regulator sounds like the way to go. May I ask how your install

Hi, We have never put any chemical in even when leaving the boat even for up to two months. I think the fact that I am very careful to avoid using the water maker in dirty of contaminated water

Best of luck to you Diego. Hope to meet you sometime. Let us know how your switch install goes. Ian & Margaret S/V Loca Lola II SM153 Bahamas

Desalator has an agent in Maine who is very helpful. Contact Marc 58 Fore St. Bldg. 30 Portland ME 04101 USA Mobile: +207 522 6737Fax: 517 813 6509 Fair Winds Eric Amel Super Maramu #376

Hi Amo, As previously mentioned and originally invented by Ian and Judy on Pen Azen there is a very simple way to remove the end cap. Just make a loop of webbing or dyneema and fasten it to the cap