Agree Bill on the solenoid. Not to difficult to take apart and clean. Porter A54-152. Excuse the errors. Sent from my IPhone Www.fouribis.net

Most likely a sticking solenoid. If you run the water maker frequently you should contact Dessalator.com for a new one. If you haven't run it for a while, monitor it and replace if it continues.

Dear Amelians, today I had a wierd situation with my duo D 100.After turning it off, it did the fresh water rinse like usual, but did not stop.I checked for a leak (in the entire boat) but there is no

Hi Stefania, If you could post the photo here it would be great - I'm curious. Craig

Courtney. I have the same loop in the wires coming out of the EJF. This am the delivery captain tells me the EJF unfurls, but does not furl. What were the symptoms of your failure? Im praying a

Marco, I attached a page from my Amel Book which my answer your question. If not, email me at brouse@... Best, Bill

Guys, Once again I would like to thank all the opinions. I removed the turbo from my boat and took it to a specialized workshop, which did a review and decarbonization. Now the engine easily reaches

Hi Yan, my Santorin # 93 has a “ disruptor “ for furled and bow truster. I will send you a photo next week, when I will come back onboard. Have a nice time Stefania Dente SN # 93 Euploia Bocca

Here is a photo of some of the plumbing under the sink of the SM. Fair winds, Eric sm376

Thanks, Bill. Kent

The SM does not have any PEX fittings. Amel started PEX with the 54

Dean, They are rated at 30amps at 12 volts, I think they will handle a lot more amps than wll be needed at 24.

Thanks Danny and Bill. I'll look under the stove, don't think I have ever been in there. Are the piping to the sinks all PEX fittings? Anybody know the size of the fittings? Kent SM243 Kristy

Porter, I like your thinking re BP analogy. If we take that further... as we can measure arterial flow with Doppler ultrasound techniques, we could use a simple flow meter installed beside the pump to

Bill, That's a nicely packaged set. I like the fixed leads which makes Porter's task easier. I am 99.9% certain that they will work just fine as you describe. The 0.1% risk: I could not find any

I previously had a source for the exact replacement of the igniter for Eno stoves needing 6 outlets (4 burners + 2 oven burners). If you are adventurous and want to try something with little risk, let

Thank you Bill. That makes it very clear. Time to head to one of my favorite spots: McDonalds Hardware. Appreciated!! Porter A54-152. Excuse the errors. Sent from my IPhone Www.fouribis.net

Hi Bill and Kent. SM 299 has a shut off valves for both the washing machine and the dishwasher below and behind the stove. Regards Danny SM 299 Ocean Pearl Mangonui New Zealand

Can anyone advise why there are two 500A Mastershunts installed at the outset. We see that only one Mastershunt is configured and visible on the monitor. The second does not appear to be visible

Kent, I purposefully said, "Later model SM2ks had the following (photo from the Users Manual)" I have no idea when the cut-off valve was added by Amel, but I have seen some SMs that did not have