From the outside of the boat while sitting in your dinghy you may be able to use a grease gun and put grease on the exterior of the valve then operate it from the inside to provide some lubrication.

Eric, Please confirm me for 1 unit, per Bill's knowledge. Bill, thank you. Jim SM384 Sirena Azul Seattle

Hi Porter, We installed a Marco 12E. All functions of the system are integrated into the pump itself. Well built! Jean-Pierre Germain, SY Eleuthera, SM 007, Opua, NZ

Thanks for answer Porter! I corrosion X and slightly change the cutoffs?? What does it mean practically. What needs to be done? Regards Arthur

You can buy a new Sware D Pressure switch almost anywhere in the world, but adjusting it can be a challenge. Google for instructions to adjust...there may be a few good videos. That said, the problem

Arthur we have the same occurrences. I corrosion X and slightly change the cutoffs and were good for about 6 months. But I’d like to know a long term solution! Porter A54-152. IBIS. Excuse the

We have the Idromini Acb Waterpump from Gianneschi. Sometimes it will not stop, the pump continues. We have to stop it manually on the pressure switch.... I have pumped up to 2 bar and cleaned the

Jim, If original SM 384 has normally closed, part number 309-0295-01 Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550

Eric, I won’t be aboard to tell witch model I have until 04 August. If ordering before then, then please cancel my order for 1 unit. Otherwise I’ll reply further on Wednesday. Thanks for doing

Hi David, Because of your remark I just remembered something about this. When I repopulated the PCBs with new LEDs I also replaced the resistors. When you buy this package from Amazon:

On my Santorin the return fuel pipe from the injectors comes off the engine and back to the tank. On top of the tank is the air vent pipe that is visible in the passage way heading out to the scuppers

Thanks Arno, Excellent information and advice, makes sense to me. I have only a very moderate knowledge of electronics and was wondering why the LEDs failed in the first place and how to prevent a

Hi Tom and Kirstin, I'm not on my boat so can't be sure, but is it the fuel return line from the injectors on each engine? That was good fortune to dodge the hurricane ! Cheers Alan Elyse SM437

Eric, It is made from EPDM, the same material that most all exterior products of this type is made from. I am sure that your insert is made from the same material. I will receive a 6 inch sample to

Is this a semi rigid material or a rubbery material? Fair Winds, Eric

Pat, once i can match up the sample i will be happy to order the insert. You can use my FedEx number to get the sample to me quickly. Kimberlite@... Eric

Hi Craig, I will be happy to order the rail insert once i can confirm it is the one that is on Kimberlite. I only need a very small piece. One foot would be fine. My email is Kimberlite@...

Hi Eric, Cancel my order, mine are normally open. I have a 1999 6.5KW MDKAL Onan. I guess that means if they fail to close, my engine gets hot and doesn't shut down. Both times mine failed closed and

Hi Craig, I

Sorry my bad. There are just too many of these things. You cannot use the constant current source I mentioned earlier. This one should work, depending on your LEDs of choice (total current of LEDs