Hi Gary, No kit number, we had to measure. And they are different, some wheels like ours with alloy spokes, some have round stainless spokes, no sure if the diameters are the same. Cheers Alan Elyse

By a small amount I think all the dimensions were different enough to need a good accurate measurement. Sorry I can't remember more details. Should have written things down... JOEL F. POTTER CRUISING

Gary- you have to remove the old cover and measure very carefully. I even sent pics of some of the measurements. Oddly, boat leather.com does not save measurements from previous orders. I was pretty

Thanks Alan- so can you see the disused holes in the wheel cover where it moves over the spoke or no ? Thomas Kleman SV L'ORIENT SM2K 422 Oahu

Thanks Joel. That would explain why two covers I got from Amel were too small. Maud didnt seem to know about the different diameters. Was the difference in wheel diameter or the size of the tube used.

I choose this solution without changing the signature of Henry Amel!! Arnold SM203 SV Zephyr Am 14.10.2020 um 21:41 schrieb amelforme <jfpottercys@...>: There were at least three distinctly different

There were at least three distinctly different steering wheels used on the Super Maramu during the production that yielded 479 examples over 16 years. I don’t remember the time period each wheel was

Ken, I have worked on boats that used the butyl tape and use it myself for applications. It is good stuff overall and I always carry some on the boat. Works best it seems on mating parts that

Hi Bill, I knew the copper vent pipe for the fuel tank in the closet area, however, I didn't know about the potential condensation problem within the closet. I will look a bit closer at the potential

Ken, Your plan should get you sealed back up. I didn't mention my recommendations for a sealant since I assume that you have a limited selection to pick from. The 5200 or 4200 will work for you.

Looks awesome! I wrote to them and asked about a kit for the SM .. Their reply was that "there are different sizes" so I needed to send measurements ... I didn't think this was the case. May I ask

Ken, Perhaps something you already did but just in case, were you able to visualize water going through the bolt? Now that you have it stripped down the rub rail you can put some water outside and

I do some services New elbow, cleaning the heat exchanger and turbo etc. My question what to do, if anything with the Stainless steel muffler? I have seen that some have had corrosion dammage is that

Ken, You probably are aware of the fact that the copper pipe vent for the fuel tank is above the area where you have a leak, and this copper vent pipe will create more water than you may realize

Hi Ken, did you consider Butyl tape as a sealant? Many prefer it to seal hatches, it stays tacky for years and years and you can easily remove it if needed. Regards, Ruslan. --

For reattaching the interior https://www.3m.com/3M/en_US/company-us/all-3m-products/~/3M-Hi-Strength-90-Spray-Adhesive/?N=5002385+3293242219&rt=rud Here is a video doing something similar on a

Thanks to all you Amelians for helping me through this mess! I think I have a good procedure for the repair now. But as aways, subject to change once I get into job. It looks as though it should

Hi Tom and Kirstin, We did our wheel with a kit from Boat Leather in 2017. How you are holding it in the pic is exactly how we did it. I sewed the cover up to where it meets the spoke cover, pulled

Ken, My boat is a 1987 Maramu so consider this information general in nature to your situation. I would suggest that you start by removing one bolt to see what kind of sealant was used

Hi David, What you are referring to as Barge cement sounds exactly like Contact cement is applied. My shoemaker uses contact cement. It is also used to adhere laminates such as Formica to