Thanks James and thanks Bill for the responses. I did disconnect the HP Switch and the water-maker worked fine. No over pressure, no over current, the usual production of water quantity and quality

One of the bolts on my main switch broke off. Anyone know if they still exist or do I need to replace it with another model? Paul on sykerpa SM 259 Lagos Portugal

Thank you all, very useful information for us. Paul on sykerpa SM 259 Lagos Portugal

Hi Mark, Just replaced all Lewmar hatch lenses due to stains on the acrylics. All the replacement lenses came with new seals. I have all the old seals in perfect condition. 2 x size 54, 3 x size 50, 1

Great as always. Thank you very much Bill. Regards Ruedi Von: "main@AmelYachtOwners.groups.io" <main@AmelYachtOwners.groups.io> on behalf of CW Bill Rouse <brouse@...> Antworten an:

In need of a Lewmar Medium Profile Hatch gasket size 50 - found a deal that may include free freight and a 10% discount. Hurry before they are gone! -- Mark Mueller Brass Ring A54

Hi Dan - It sounds like your problem may be rooted in the HP switch as you sate, but I am curious if anyone on board was able to watch in the engine room to determine if the first event to occur was

Dear Dan, Agree with both suggestions. Either the HP sensor is the issue, or the board believes it does not reach adequate high pressure. Agree with placing needle dead in the green to high within

Hi Dan, On my 54 I have had a similar experience. After the unit has been shut down for the winter, when I recommission the boat, this automatic shut down happens sometimes. I have found that it is

Dan, Look for an email from me in a few minutes. A quick workaround is that the Pressure Sensor is a normally open (NO) switch. Disconnecting the electrical leads, takes it out of the circuit. Also,

Hello Dan; We have the same water maker aboard Kokomo. However, I’m not sure if it is the same or a later design. Going through your procedure, I have one recommendation. I see that you state

Good morning all, On sv BeBe, SM#387, I have the original Dessalator 230v 160LPH water-maker. Today was the first time I this season that I have tried to run the water maker (as we were in the

678 L x 70 H x 25 D; millimeters -- Mark Mueller Brass Ring A54

Many thanks Kevin, will look him up

Nick, I found an awesome guy who just did our 2003 Amel SM. He was phenomenal! Nick Lombardi +1 (978) 479-3864 charlestonmarinesurvey@... I highly recommend him. Very professional, courteous and

Would anyone be able to recommend a surveyor in the Charleston area please? Ideally one with Amel experience. thanks

Thanks Mark but I’m talking about the crossbar

Hi Paul! We had a webasto 10kw hydronic water heater on our previous Beneteau 50. We sailed in the Baltic winter and the boat was pretty warm in all cabins, even the temperature dropped under zero

Glad it was useful. I'm big on checklists. I agree with your statement and love the phrase "between terrifying and hysterically funny" I think I'll use that alot as it captures many moments we have

He all ever thought about switching the 12-V altinator to charge the launch battery for a 24-ounce and using the service batteries to speed up the charges. If we're charging the launch battery,