Hi Chris, I think youre right about the solenoid. We had the same issue a year ago. The fresh water pump did run every 15 minutes. For weeks we were looking for a leakage without any success. Finally

On Fri, Apr 30, 2021 at 02:32 AM, Brent Cameron wrote: From there you will see all of your default tag lines for each of the Groups.IO forumsHi Brent, I liked your suggestion, but it doesn't work for

I think you’re right about the solenoid. Ours also stuck open several years ago. It has to be physically taken apart, cleaned with Emory cloth and then reassembled. That was 3 years ago for us. Been

Hi All, I just started having a new issue with my fresh water pump. Ill start by saying I have Amel54 #133 with 180l/h dessalator wm. I recently ran our water maker as normal. After shutdown it began

It is the saloon table extension! /A

Hi all After a cold winter on board ,I would like to install for the next one , heating through pulsed air in the main cabin. For that I need to have a stainless steel pipe going through the rear

Bill, Just replacing mine (Santorin), 1" boss fits fine. Question is what length. The old one is shorter than the ! length of the sleeve, but this may be wear a d compression. I am assuming it should

I've noticed over the years that a lot of people forget to post their boat name, model and location after their posts and this generally results in someone else asking for the same information in

Thank you, Doug One of my problems is that my bow thruster is a 12 volt system... based on your experience I will try to have it refurbished. Andre Renaissance 2000 Mango 7188 Westbrook, CT

Andre, My bow thruster on the 54, failed on the lifting motor. I went through an extensive search for the lifting motor for the bow thruster motor on my 54. Amel was only able to source the entire

Bill, In fact it’s a 12 volt system. I will inquire if they make a 12 volt model Thank you, Bill

Billy, After multiple quotes and sticker shock, Bill helped me find Manifest Marine. Elliott (540-834-8435) took the time to understand where I was planning to spend the next 12 months and quote a

Be careful, the shape is not at 90-degree angles. CW Bill

I am not sure if the Actuator in the Mago is the same as the SM which is 24 volts, but this info may help you. The SM actuator is Model Number: ACLE105 and made by: SNT 2 rue Marcel DASSAULT ZI de la

Hi, What model Amel do you have? Fair Winds Eric Kimberlite Amel Super Maramu #376

Pierre, Thank you ! Fair Winds Eric Kimberlite Amel Super Maramu #376

Thank you Bill I have not seen something similar in the AMEL 54 Unser’s Manual not in the AMEL Owner’s Guide. Nevertheless your information is welcomed and a good starting point, and I will

Dear ALL, I would need the measurement of the seats in the cockpit, I am not sure done it right and now fare away of may boat. Thank you for answer! -- Arnold SY Zephyr SM203

To all, I have a 1989 Mango and the motor that raises and lowers thruster propeller appears to be dead. Does anyone know where to source such a motor? Andre Kaplan Renaissance 2000 Mango 71 88 Begin

Hi Eric, Yes, had those made at machine shop. Rough measurements: 2 5/16 widest; 1 1/2 height; 3/16 thickness I asked the shop to make another sample but using SS 316, and thinner. (Thanks Bill