Kevin if you are using shore power in Newport, it is 60 hertz and will ruin the washer. There is no other breaker, except for the main 220-volt breaker and the main breaker on the side of the Onan.

Sorry but French auto correct. Dock Breaker Envoyé de mon iPhone

Hugh K & K Sorry to ask but are you at the port and in that case it might be the dock n’étaler ! Alain Koriolys SM 146 France Envoyé de mon iPhone

The shock cord that holds the lee board in my cabin has seen better days. It is behind the door to the head. Does anyone know how to get to the ends of the shock cord? Has anyone devised a method

I am not aware of another breaker after the panel. Suggest youfollow the wire from the breaker panel to the washer with one of these:

Dear Amelians, Successfully completed two complete wash loads and went to do a third and noticed no power to the washing machine. I checked the circuit breaker on the 220 volt panel and not tripped,

Bill, Two years ago, I replaced my chargers for Mastervolt 60 amp and 100 amp. According to the specs for the 100 am charger a cable AWG2 is perfectly fine and thus it can be connected to the

Hi Eric, Until about 3 or 4 years ago I used the recommended method that you describe, using not one but two hose clamps to make sure I will not drop the BT into the water, or worse, on the ground as

Thank you Eric, I currently have a Viking 6-persons (to be politically correct) raft and have carried it on the same locker as you with the ditch bag for 10 years. However, It and I are both becoming

@Aras Grinius Can you please send again your file Guillatine Rebuild.zip ? It does not open here. -- Gerhard Mueller Amel Sharki #60 Currently Port-Saint-Louis, France

Take pictures when you do it! -- Jason Rutledge SV Liahona SM 335

As long as you drill through vertically above the existing cables in the cable way, you will miss the fuel tank. I know, I've done it. Cheers Alan Elyse SM437

I believe that is a Deaerator. I have not seen this on other 55s. I probably missed it. Thanks, Bill

Another try on the photo. ´

Hi, Yes the central spindle does pull out from the top. It can be stubborn at times but it should come out once you have removed the two or three inserts that sit at the top of the tower where the

Joerg, Photo of Deaerator? I think you forgot and please tell me where it is located. And one thing a lot of people forget is that slower saltwater flow means lower heat exchange efficiency. Bill

Thanks very much, Bill. I‘ve pretty much followed the instructions regarding bleeding air from the manual but only one of my three chiller units has a valve to bleed air. I’ve bled air from

 Areas, I elected to lift the dodger since I was not confident in my ability to do a good woodworking job in Greece. My other two choices were to cut the hatch in half or cut the trim and rebuild

Joerg, You just brought up one of the continuing issues with some 55 owners. I have tried to learn as much as I can about the Climma Chiller System and maybe I can offer a few things that you have not

You can drill new holes above them through the bulkhead there’s an area in front of the tank that small just above where the cables penetrate right Within the foot step. Make sure you know we are