Arno, yes please. Peter Forbes on ppsforbes@gmaildotcom Amel 54 #035 -- Best wishes Peter Forbes +44 (0) 7836 209730 ppsforbes@...

Dear Forum, For those that still have the original navigation chair in their A54 and may be looking to replace the existing upholstery I have a nice set available that I used to re-upholster our chair

I have had some HVAC technicians add a leak sealer with the freon for very small leaks. Fair Winds Eric Kimberlite Amel Super Maramu #376

HI Darren, I used one of these found on Amazon 25Ohm worked me. https://www.amazon.com/gp/product/B089Q88QPN/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Chris Amarok, SM385

So the fridge guy came this morning. He thinks any leak is very very slow and charged it with gas. Works fine but I have my doubts. Given my time constraints here in Volos we will carry on with the

Hello Jose, Can you kindly advise where we can purchase the silicon BT seals you refer to in your below email? And are you still happy with the upgrade of same, you installed in your SM2K? We

Hi Chris i have just brought the Nac 3 computer and will need to solve the clutch operation, could you share with me what specific brand, type of 25Ohm resistor you used? Cheers Darren SV Wanderer,

I created #dinghyanything regarding dinghies, tenders, kayaks, or outboard engines

#dinghy, #tender

I was thinking of using the alternator off a small tractor of some such. The alternator on my auxiliary is running at a 1:2 ratio and cuts in at 1000 rpm. I can fit a five inch pulley on the shaft and

Thanks Mark,that looks about how I expected it to. Is there a manufacturer’s model number on the alternator? I can’t read the data plate in your photo

Minerva has the original Perkins 4.154 with a ZF transmission. I don’t think the shafts are interchangeable.

If you are a bit of a contortionist you can get to the compressor and board by just sliding the the box forward. If possible have a filter/drier installed if you open the refrigerant lines, Frigoboat

I just installed a new Frigoboat stainless refrigerator on my SM2K. No real issues. After disassembling the washer/dryer cabinet and getting that out of the way, I slid out the old fridge and

The forum does it again. Thanks. I am tied up in Volos and the refrigeration engineer is coming tomorrow at 9 am. Nick Amelia AML 54-019 Volos Gr

Hi Nick. No need to unscrew the refrigerant lines, at least not on A54 #117. Disconnect the electric wires from the control box and disconnect the water hoses (after shutting down the water line in

Hi Nick, In my 54 #29 I just removed the fridge to change the thermostat. I had to remove the door to get it out, but after disconnecting the power and cooling water tubes it comes out in one piece.

Lance, The reinstallation of a shaft generator seems like a simple project. You would need to know the speed of the shaft when cruising. Once you have that information, I would go to a shop that

Lance this is a photo of my Shaft generator, from 1983. I have not got anything out of it yet and will soend some time tomorrow checking the connections. I also have a switch inside the cabin. If I

if my memory serves me right it’s just like the SM2K just shifted to port (next to sink, other side). If you haven’t seen this: https://nikimat.com/fridge_removal.html We removed ours on my