Doug, Thank you. I just sent you personal email. This takes care of the Vetus coupling. Ill check with a Vetus distributor to see if they can provide a new shaft flange assembly. Let me know if

Kevin, I have a spare Vetus coupling that looks to be from Vetus directly and would be easier for a machine shop to get to the Amel version. Came with my boat as a spare when I purchased 18 months

Unless something has been changed, bolts and nuts secure the Vetus coupling to the Output Coupling of the ZF25. Some owners have used threaded rods with nuts on each side. Whatever you use, make sure

Kevin and Kristen, ust arrived in Rockland this afternoon. Would be interested in meeting tomorrow, Saturday.. Where are you located in the Harbor? We’re on the schooner dock near the ferry

Guys, thank you all for the support and information. Amel is on vaca until the end of the month. Bill has given me some drawings of the coupling to bring to a machine shop for fabrication.

Hi Kevin, I cant help other than to say these used to be readily available when I needed new bushes. But I will say you were very lucky it was the vetus coupling that failed. One SM I know got a prop

I wonder how fast Kimberlite would go with 1800 horsepower . CAN You Believe this setup? Fair Winds Eric Kimberlite Amel Super Maramu #376’

Sorry, I did not read your entire post. I would still disconnect the coupling and disk brake to see if the drive spins freely. I would also check your prop. The removal of this coupling has been

This is a Vetus coupling that is remanufactured by Amel. It is only available from Amel. Unfortunately, they are closed until the end of the month. The coupling is very strong, and I am surprised

Hello, we are currently stuck n Rockland, ME after hitting a lobster pot and fracturing our Vetus Coupling. In addition to replacing the rubber bushings (Vetus kit #K018), I also need to replace the

Hello Pierre, I believe I saw a photo of your deck hatch reinforcement. I would like to order a few. Please send me a photo to verify and the approximate cost. Fair Winds Eric Kimberlite Amel

Several people have contacted me offline for their small order of this part. I'll be placing the large order with the machine shop in about 10 days. Anyone else interested, there is still time.

The upholstery has found a new boat. Cheers, Arno Luijten SV Luna

Hey, I don't know if it fits the jib furler. I didn't write down the measurements but I try to remember: diameter: 31 mm the top grove is 15 x 17 mm (the sharp edges have to be rounded) on the bottom

Thank you Eloi. Do you have measurements for this piece? Do you know if it fits in the jib furler as well? I am having trouble with the rivets holding the jib furler to the foil on the forestay.

Arno, yes please. Peter Forbes on ppsforbes@gmaildotcom Amel 54 #035 -- Best wishes Peter Forbes +44 (0) 7836 209730 ppsforbes@...

Dear Forum, For those that still have the original navigation chair in their A54 and may be looking to replace the existing upholstery I have a nice set available that I used to re-upholster our chair

I have had some HVAC technicians add a leak sealer with the freon for very small leaks. Fair Winds Eric Kimberlite Amel Super Maramu #376

HI Darren, I used one of these found on Amazon 25Ohm worked me. https://www.amazon.com/gp/product/B089Q88QPN/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 Chris Amarok, SM385

So the fridge guy came this morning. He thinks any leak is very very slow and charged it with gas. Works fine but I have my doubts. Given my time constraints here in Volos we will carry on with the