I also have a mhu213 with a broken plug you can take it from me too Verstuurd vanaf mijn iPad

HeyI replaced the mhu 213 with the signetgreetings Verstuurd vanaf mijn iPad

Dear Amalians, my windsensor ( MHU) model B & G 213 finally gave up. Apparently B & G cannot supply the PCB , and i am in doubt if they will in the future. Is there anyone out there who has a

Good evening, Does any one know of a reliable/reasonably priced Yanmar parts distributor in Miami, Florida? -- Alex Paquin S/V " SIMPATICO" Amel Maramu Hull #94, 1981

I was thinking of that but I wanted to be conservative.

Nah, Amateur class. You should go for the new Mercury V12 600HP. 2400 HP should get Kimberlite moving nicely for at least 30 minutes before you run out of fuel... Regards, Arno Luijten SV Luna

Kevin, You might make a quick call and email to amel.caraibes@... +5960690381021 in Martinique. Alban Leroy is the manager there and when we had our (SM429) Vetus replaced they had one in stock.

Mike, I’ll swing by on the dinghy in the morning. we’re on a mooring in front of Rockland Marine. -- Kevin & Kristen Schmit KIANA SM #362

Doug, Thank you. I just sent you personal email. This takes care of the Vetus coupling. Ill check with a Vetus distributor to see if they can provide a new shaft flange assembly. Let me know if

Kevin, I have a spare Vetus coupling that looks to be from Vetus directly and would be easier for a machine shop to get to the Amel version. Came with my boat as a spare when I purchased 18 months

Unless something has been changed, bolts and nuts secure the Vetus coupling to the Output Coupling of the ZF25. Some owners have used threaded rods with nuts on each side. Whatever you use, make sure

Kevin and Kristen, ust arrived in Rockland this afternoon. Would be interested in meeting tomorrow, Saturday.. Where are you located in the Harbor? We’re on the schooner dock near the ferry

Guys, thank you all for the support and information. Amel is on vaca until the end of the month. Bill has given me some drawings of the coupling to bring to a machine shop for fabrication.

Hi Kevin, I cant help other than to say these used to be readily available when I needed new bushes. But I will say you were very lucky it was the vetus coupling that failed. One SM I know got a prop

I wonder how fast Kimberlite would go with 1800 horsepower . CAN You Believe this setup? Fair Winds Eric Kimberlite Amel Super Maramu #376’

Sorry, I did not read your entire post. I would still disconnect the coupling and disk brake to see if the drive spins freely. I would also check your prop. The removal of this coupling has been

This is a Vetus coupling that is remanufactured by Amel. It is only available from Amel. Unfortunately, they are closed until the end of the month. The coupling is very strong, and I am surprised

Hello, we are currently stuck n Rockland, ME after hitting a lobster pot and fracturing our Vetus Coupling. In addition to replacing the rubber bushings (Vetus kit #K018), I also need to replace the

Hello Pierre, I believe I saw a photo of your deck hatch reinforcement. I would like to order a few. Please send me a photo to verify and the approximate cost. Fair Winds Eric Kimberlite Amel

Several people have contacted me offline for their small order of this part. I'll be placing the large order with the machine shop in about 10 days. Anyone else interested, there is still time.