Hi Matt, We have paid a lot of attention to our consumption habits over our years of cruising and we went with 2 @ 385w LG panels as we did not want to increase the size on the back arch. We still

Having Lady Annila on the hard just a few minutes drive from the appartment has resulted in a far more extended renovation of the boat during winter moths, summer we have been able to sail along the

When COVID hit in spring of 2020 we were in Ile de Saintes (Caribbean). We spent an idyllic two months.locked down there with a great small community of cruisers. Then with all of the southern islands

In my first recharge, it lasted 24 hours and was empty. My second recharge used a leakseal and now it lasted 7 days. I filled it again with another leak seal and it was working for a week when a tech

Living on our super maramu has been a godsend the past 2 years of lockdowns here in Europe. We're not ever in a hurry though, so. Got my whole to do list done over last winter, been hanging around a

Hi Alan, Thanks for the alternative. rgrds Els & Eric Opdeweegh sv Abayomi SM hull 158 Currently in Rotterdam The Netherlands

I can't help with getting new ones but Bill and Karen off Harmonie put us onto these. We use them on all the ports and saved the good rubber disk for future use. Can buy them at the local hardware

Appologies, I should have searched first before asking questions...this forum is such a treasure of information. There is Olaf's document about rudder

Dear Amelians, We have been searching for replacement of the rubber knobs that keep the doors from the front cabin open and that keep the port holes open. The dimensions are diameter cylinder 20 mm/

Hi. If you look you will find an access hole down through the rope pully. You can access the screws one at a time through this. You need a heavy duty Phillips screwdriver. Regards Danny SM

Living in London, we spent 6 weeks in the Aegean, (Greece, not Turkey ) last autumn; then June this year and we will spend Sept and Oct afloat as well. The limitation for us has been the 90 days in

Hallo, I am wondering how to dismantle the electric curler in order to put in the apparently three screws that fix the small grey disc to the motor unit as seen on the foto/video. I need to sand and

please find herewith picture of 3x400wp sunpower. they are 50cm above the davits, in-line with the mizzen boom.

We got stuck in French Polynesia before the borders closed andare LOVING it here. FP allows the boat to stay for 3 years before import tax isdue and us as long as we like on a long stay visa. The

East coast USA is open. We're in Maine this Summer and only occasionally required to wear masks, almost exclusively in government-run facilities like museums. We hope to sail to Caribbean and thru

We have our Sharki in a marina in Malaysia. We haven’t been able to get back to her since covid struck. Either due to immigration restrictions or our own decision not to expose ourselves to covid

I'll try the pic again, thought it had worked last time. -- Kent & Iris KRISTY SM243

Actually, though cruisers are allowed in Fiji waters, they have a very high COVID infection rate. Go there at your risk now Jean-Pierre Germain, Eleuthera, SM007, NZ

Paul I spent the season sailing. First from Georgia to St Thomas. Then sailed the Spanish and USVI until May Then south to Grenada 🇬🇩. Was overall easy, occasionally a few hoops, not what I

Since year ago June, I have been sailing on the East coast of the USA, the Windward Islands, Bermuda, and the US virgin islands. No real problems just a lot of testing and paperwork. Fair