In this Order Check the main breaker on the aft side of the Onan. Check the automatic shore power/generator circuit and relay Call an Onan tech

Hi Joan, Have you checked the trip switches? There is one on my 54 in the galley area above the sink in cupboard beside ac panel. There is also one on the Onan itself… Kind regards Nick S/Y

Hello, My Onan generator is running well and I get 13.6v on the cables directly on the generator. On the Onan display panel I see 230v and I don't get any errors. Unfortunately on the 230 V AC galley

Dear Bill, Thank you for the positive view and realistic expectation of performance. Kind regards Mike & PETA Solitude SM2k 461

TruDesign offers through hull fittings as well as their ball valves. Because they are in plastic no bonding is needed. However the dimension of the ball valves is a little bit larger than the bronze

I am the proud new owner of a Maramu #69, this forum is a wealth of information which I am very appreciative of. I have some rectification work to do on the boat and one of the priority jobs is to

Mike & Peta, I used an Airmar WX220 on my old boat, and it worked fine. This unit is not as accurate (especially with wind direction) as the B&G unit, but for must cruising boats that's not a big

Calling all SM owners in NZ. Having done a small run of the copper grounding straps for the grey-water bilge, and been happy with the results, I am now planning on getting some AMEL-specific tools

All the best for 2022 to all Amelians For those who are interested, here a supplement on the subject of fully battened main: By chance, I spoke to the former owner of the Super Maramu Stenella

Dear Eloi & Ian, Thanks for the information. I will replace the B&G with an ultrasonic wind sensor. Very best wishes Mike & PETA Solitude SM2k 461

Great info. Bob, thanks. Unfortunately the photos link doesn't work for me. It says the link has been deleted or the URL is invalid. Can you send them directly to

Hi again Eric (not Ken - sorry about that). I will have 1 of these Hightech temperature exhaust pipe cut out switches. I will email you with ship to details. Very Best Barry “SV Lady Penelope

No interferences with VHF nor AIS. Eloi

Hi Eloi, Thanks for the prompt response. Do you get any interference with the VHF? Very best wishes Mike & Peta Solitude SM2k 461

We installed an Airmar 220 WX two years ago. Very happy with its performance. Ian & Margaret Loca Lola II SM153

Hello, I refitted with the LCJ / CV7 with Windyplug. CV7-WINDYPLUG - NMEA2000 ultrasonic wind vane-anemometer (lcjcapteurs.com) works great, recommend it. You can reuse 2 of the mounting holes. With a

Happy New Year Everyone, Our B&G wind-sensor has eventually expired (casing shattered whilst B&G attempted to replace bearing). We are now considering replacing the unit with an ultrasonic wind sensor

On Mon, Jan 3, 2022 at 11:55 AM, Eric Freedman wrote: kimberlite@...I'd like the last one please. Emailed you seperately.

Hi Mike, I do not have an ohm meter here. Please check your parts manual. It would not be cost effective to ship to NZ. I Have 1 switch left now. Fair Winds Eric Kimberlite Amel Super Maramu

H Eric, The five spares you have are all normally open or normally closed exhaust temperature switches? Cheers, Mike Longcor SV Trilogy SM23 NZ