Last year I had new plastic windows on my spray hood as the old had gone opaque. I have spayed the whole thing with waterproofing agent but the stitch holes around the new windows drip a bit in rain.

Where is the photo section located on the Amel website? Fair Winds Eric Kimberlite Amel Super Maramu #376

Steve, If the bowthruster hasn't been used much, wear on the shaftseal is likely to be minimal. On the other hand, the replacement parts are cheap and it's about a half day of work. So we service

I forgot to mention that I use lacquer thinner to clean the surfaces before I install the seal. Fair Winds Eric Kimberlite Amel Super Maramu #376

I have changed the bow thruster seals about 12 times and rebuilt it once. I have never had to take apart the bow thruster to change the shaft-propeller seal. Except when I had to change the gears

On Kimberlite which has a Yanmar, I have every spare part that can be replaced at sea. My spares have all gaskets, including the head gasket. All senders, starter, pumps, both alternators, hoses, the

Mike, I AGREE! I can edit the subject line and I will freeze the thread. Kimberly, please look up the use of the term mayday. It is not used for things like this. -- Best, CW Bill Rouse Amel

You should be aware that the Volvo France modified Volvo D3-110 for Amel to have an Isolated Ground. Because of that important modification, the Amel-installed D3-110 in the A54 has some parts that

Roland, I want to remind you and Ian of what I say too often. Just because 1 SM has something installed, doesn't mean they all do. I do not believe the fuse that Ian has is Onan or Amel installed. We

https://www.marineparts.eu/spare-parts/va-inboards/volvo-penta/engine-parts -- Bernd SN 119 / NOMAD

Hi, Can we please the word Mayday from this thread. Every time I see it shudders go down my spin. Thanks Mike Solitude SM461 Get Outlook for iOS

All, Regarding the bushings pictured below for the genoa furler, the manufacturer for Amel of the genoa furler says, "The pictured part is not of my manufacture, it could be for the very first genoa

Thanks, Bill K. I hadn't heard that before. I'll check it out when I service the BT next week. -- Kent & Iris KRISTY SM243

Hi Mark, I struggled to find just the caps, though a source for them must exist somewhere. We found that the caps off of a standard, inexpensive pushbutton switch fit perfectly. We found them for as

Steve, Bill knows his seals. IMO a lot of the sealing with the bow thruster in the up position is done by the black foam donut seals that are in compression. These take a set when compressed over

I don't have a photo. It's on the port side of the generator, low down. Hard to find. Trace back from the starter.

Hi All. I replaced the seals on my bow thruster approx 2 years ago same process apart from struggling to find the stews as matured it was an easy process. On Bill,s recommendation at the time

Hi everyone, We are in the acquisition process of a A54 for a world tour. We are looking for a Spare Parts List for the Volvo D3 110 engine as well as for the boat. Your help will be very

Hi, Can we please the word Mayday from this thread. Every time I see it shudders go down my spin. Thanks Mike Solitude SM461 Get Outlook for iOS

Hi Bill and Ian Thanks for the hint. We’ve checked this circuit breaker already, and it’s on. It seems that the control unit doesn’t have 12v, although 12v are supplied to the generator. So, we