|
Re: Shaft generator doesn’t load
Roland,
What is the current voltage of the batteries? If it is VERY, VERY low then there might not be enough voltage to generate the required field current. I think this is unlikely, but
Roland,
What is the current voltage of the batteries? If it is VERY, VERY low then there might not be enough voltage to generate the required field current. I think this is unlikely, but
|
By
Bill Kinney
·
#64076
·
|
|
Re: A54 backstay and staysail and genaker blocks
I have always put the runner block on the outboard lifting chainplate and run the line to the winch.
However I think it works better to run it to the small mainsail backstay plate. It leaves the
I have always put the runner block on the outboard lifting chainplate and run the line to the winch.
However I think it works better to run it to the small mainsail backstay plate. It leaves the
|
By
Nick Newington
·
#64075
·
|
|
Changing end-caps Desal
This morning I changed the Desalateur end caps.(160l)
The only thing I want to add to the common knowledge is that I found that the air blower needed to be dropped in order to access the forward
This morning I changed the Desalateur end caps.(160l)
The only thing I want to add to the common knowledge is that I found that the air blower needed to be dropped in order to access the forward
|
By
Nick Newington
·
#64074
·
|
|
Re: A54 backstay and staysail and genaker blocks
Hi Teun, there are couple things that worry me in this setup. On port side bug winch is in the way and also while sheets are trimmed I’d prefer not to close the jammer. In the case when you need to
Hi Teun, there are couple things that worry me in this setup. On port side bug winch is in the way and also while sheets are trimmed I’d prefer not to close the jammer. In the case when you need to
|
By
Ruslan Osmonov
·
#64073
·
|
|
Re: Event: PredictWind Presentation by Keyrn McMaster, Ocean Racer and Executive with PredictWind - 06/18/2022
#cal-reminder
Hey Bill,
Did not have good enough cell reception yesterday. watched the Youtube presentation instead…. Excellent and informative..
Kind regards
Nick
S/Y Amelia
AML 54-019
near Marmaris Turkey
Hey Bill,
Did not have good enough cell reception yesterday. watched the Youtube presentation instead…. Excellent and informative..
Kind regards
Nick
S/Y Amelia
AML 54-019
near Marmaris Turkey
|
By
Nick Newington
·
#64072
·
|
|
Re: PredictWind Presentation - and some extra info on GRIB files
Thanks David,
All clear - I will take a look at Weather4D and maybe we can talk about it if/when you make it back to the Marina here.
So far I have, for passage etc., only relied on PDW plus
Thanks David,
All clear - I will take a look at Weather4D and maybe we can talk about it if/when you make it back to the Marina here.
So far I have, for passage etc., only relied on PDW plus
|
By
Teun BAAS
·
#64071
·
|
|
Shaft generator doesn’t load
Hi,
Our shaft generator was working fine, but after a total breakdown of our 24v supply (24v alternator defective and Onan generator not starting), it doesn’t load anymore.
Before the 24v
Hi,
Our shaft generator was working fine, but after a total breakdown of our 24v supply (24v alternator defective and Onan generator not starting), it doesn’t load anymore.
Before the 24v
|
By
Roland Mueller
·
#64070
·
|
|
Re: Furler solenoid wiring from switch
Saga still on...
Shaken the soleniid and put back, worked for a little while and again...lioking for a new one including at amel - amel could offer only a volvo solenoid with 2 main pins (ratger then
Saga still on...
Shaken the soleniid and put back, worked for a little while and again...lioking for a new one including at amel - amel could offer only a volvo solenoid with 2 main pins (ratger then
|
By
Ben "Santorin LO"
·
#64069
·
|
|
Re: Windless Rubber Caps
If you need the entire switch with rubber cap, you can buy from Vetus here in USA for $43/ech. See info and part# below:
Kevin,
I apologize for the delay.
AFSTPB is only one direction. You
If you need the entire switch with rubber cap, you can buy from Vetus here in USA for $43/ech. See info and part# below:
Kevin,
I apologize for the delay.
AFSTPB is only one direction. You
|
By
Kevin Schmit
·
#64068
·
|
|
Shaft generator doesn’t load
Hi,
Our shaft generator was working fine, but after a total breakdown of our 24v supply (24v alternator defective and Onan generator not starting), it doesn’t load anymore.
Before the 24v breakdown,
Hi,
Our shaft generator was working fine, but after a total breakdown of our 24v supply (24v alternator defective and Onan generator not starting), it doesn’t load anymore.
Before the 24v breakdown,
|
By
Roland Mueller
·
#64067
·
|
|
Re: PredictWind Presentation - and some extra info on GRIB files
Hi there Teun,
With regards to: " Weather4D allows me to easily run and re-run various routing scenarios whilst underway, without needing to go online each time, as is the case with the PW Offshore
Hi there Teun,
With regards to: " Weather4D allows me to easily run and re-run various routing scenarios whilst underway, without needing to go online each time, as is the case with the PW Offshore
|
By
David Vogel
·
#64066
·
|
|
Re: A54 backstay and staysail and genaker blocks
Correction below in red.
Best Regards Teun
SV AMELIT A54 #128
HOPE ISLAND MARINA (near BRISBANE) QLD AUSTRALIA
June 19, 202210:48:41
You can follow AMELIT via this
Correction below in red.
Best Regards Teun
SV AMELIT A54 #128
HOPE ISLAND MARINA (near BRISBANE) QLD AUSTRALIA
June 19, 202210:48:41
You can follow AMELIT via this
|
By
Teun BAAS
·
#64065
·
|
|
Re: PredictWind Presentation - and some extra info on GRIB files
Morning David,
When using Weather4D on an iPad during passage (see yellow highlighted section below) where & how does Weather4D gets it updates if the iPad is not connected to the internet or
Morning David,
When using Weather4D on an iPad during passage (see yellow highlighted section below) where & how does Weather4D gets it updates if the iPad is not connected to the internet or
|
By
Teun BAAS
·
#64064
·
|
|
Re: A54 backstay and staysail and genaker blocks
Hi Ruslan,
I have the Stay sail sheets running thru the fore & aft adjustable car on the applicable side on the foredeck; from there thru the “eye let” on the side of the hard dodger and then
Hi Ruslan,
I have the Stay sail sheets running thru the fore & aft adjustable car on the applicable side on the foredeck; from there thru the “eye let” on the side of the hard dodger and then
|
By
Teun BAAS
·
#64063
·
|
|
Re: Windless Rubber Caps
Just the caps or the whole switch? I am looking for replacement caps.
With best regards,
Mark
Skipper
Just the caps or the whole switch? I am looking for replacement caps.
With best regards,
Mark
Skipper
|
By
Mark Erdos
·
#64062
·
|
|
Re: PredictWind Presentation - and some extra info on GRIB files
Good ZOOM hook-up - thank you Bill & Tilo for organising and moderating.
I learnt a few good things: use of high-resolution models for local forecasts; and the better speed of the PWoffshore APP
Good ZOOM hook-up - thank you Bill & Tilo for organising and moderating.
I learnt a few good things: use of high-resolution models for local forecasts; and the better speed of the PWoffshore APP
|
By
David Vogel
·
#64061
·
|
|
Re: Windless Rubber Caps
Hi Mark,
I bought them from Jaycar in Australia...actually in the shop, not online.
Cheers
Alan
Hi Mark,
I bought them from Jaycar in Australia...actually in the shop, not online.
Cheers
Alan
|
By
Alan Leslie
·
#64060
·
|
|
Event: PredictWind Presentation by Keyrn McMaster, Ocean Racer and Executive with PredictWind - 06/18/2022
#cal-reminder
Reminder: PredictWind Presentation by Keyrn McMaster, Ocean Racer and Executive with PredictWind
When:
06/18/2022
20:00 to 21:00
(UTC+00:00) UTC
Where:
Group Zoom Meeting
Organizer: Bill
Reminder: PredictWind Presentation by Keyrn McMaster, Ocean Racer and Executive with PredictWind
When:
06/18/2022
20:00 to 21:00
(UTC+00:00) UTC
Where:
Group Zoom Meeting
Organizer: Bill
|
By
Group Notification <noreply@...>
·
#64059
·
|
|
Re: Windless Rubber Caps
Mike,
Fantastic! For the life of me I cannot find these switches or anything like it in the USA. However, I found what appears to be that exact switch sold by Jaycar on AliExpress for US$2.19 each.
Mike,
Fantastic! For the life of me I cannot find these switches or anything like it in the USA. However, I found what appears to be that exact switch sold by Jaycar on AliExpress for US$2.19 each.
|
By
Mark McGovern SV Cara
·
#64058
·
|
|
Re: Windless Rubber Caps
Hi Mark,
I bought them in person so I don't have a link, but those look exactly right. I think the profile is slightly taller than the originals (just a couple mm). This doesn't really matter as you
Hi Mark,
I bought them in person so I don't have a link, but those look exactly right. I think the profile is slightly taller than the originals (just a couple mm). This doesn't really matter as you
|
By
Mike Longcor (SV Trilogy)
·
#64057
·
|