Bryce, The answer is "it depends." How do you use your boat? If your boat spends most of its life connected to shore power, and if that is the only place you want to use hot water, then an electric

Thanks everyone, it turned out to be the Generator start battery. I have dedicated start batteries for the engine and the generator and confirmed the generator start is dead by cutting off shore power

Aqua Signal 34 navigation lights will run just fine on a normal 24 Volt system, including the absorption charging voltages of close to 29 Volts. We have used them for years without an issue. The only

Hi Ulrich, hi Bill, thanks for your quick response Martin Mago del Sur - 54#40 currently Île de Porquerolles France

Hi Franz, Thank you for your answer. The marine version is far too expensive. I know about the continent restriction of the RV version. You just have to change your address to the new continent ( it

Hi Eloi, I have been a Starlink user for 1 year plus and can tell you that the antenna is very sensitive to obstruction even just from leaves, tree branches. I would expect the antenna needing to be

Hello, I just ordered a Starlink RV and try to figure out where to mount the antenna. I would prefer to mount it fix under deck. The only place I found till now is above the chart table in the middle

Thanks, Teun, I will communicate with Caterina. Louis

Hi Louis, Let me check with BAMAR and I will come back to you. Earlier BAMAR/Ms. CAMMAROTO sent mein trust a confidential video – to help me out. Although, for a while, I was not happy with

Hello Teun, I still have one BAMAR MEJ 2 installed on AMELIA II on the Genoa. This unit is now using the motor that was on the staysail system which I replaced last year by a manual furling system

Further (and hopefullyFINAL) update: BAMAR is sending 2 motors & brake sets to AUSTRALIA this week prior to their closing for the Summer Holidays this Friday (tomorrow). They offered a

Hi Christian, That is a bit confusing. Sorry I don't have the answer. I ended up sourcing the gaskets through a local chandlery. They charged 12.59NZD which is about 7.77euro per meter. So hopefully

Hopping on this one- Thanks for the info, Mike Do you know if the prices listed on their site are per meter? if so the hatch gasket pricing is confusing, as said 6.02 when click quantity, but has

Hi Lance, If they are tradition portlights, the seal is 8mm diameter round EPDM foam. Here's one website that can supply it:

I think you might have the Tradition Series. Start by downloading the following: Goiot Distributors.pdf Goiot Tradition Hatches Catalog.pdf CW Bill Rouse Amel Owners Yacht School +1 832-380-4970

I have these screws here (in the yellow mark) Regards Marian

Time to replace the portlight and hatch seals on Minerva, Maramu #135. I looked in the wiki-how on this site, but the attachment with Bill Rouse’s response to a similar question was deleted. Does

I asked them soecificalky about this. This was the response: ================= Dear Arno, thank you for your email and pointed out the incorrect information on the website. We will arrange to make

This is the best rigger in Europe, although there are other good ones. https://preparetocastoff.blogspot.com/p/nicky-rigging-marine-services.html Bill CW Bill Rouse Amel Owners Yacht School +1

Good morning! I have discovered one of my floorboard hatches is broken and needs replacing. I emailed Maude a couple days ago and am awaiting a reply. In the meantime I thought I’d check with the