Hi, since my old bats will die soon I decided to go LiFePo. It will most likely done out of on hand, meaning the Victron main Importer in Turkey. please advise and let me know the little things to

Follow Porter's advice. Here is a link to my Amel Book Supplement on this issue: FlareTite Seal for JIC Fittings.pdf Here is a snippet from my Amel Book page 211 of 400: CW Bill Rouse Amel Owners

Hi Nick, Porter, Thank you indeed, you give me confidence. Will undertake this at the first opportunity. -- Dean Gillies SV Stella *****, Amel 54-154

This is what Dessalator recommends. (Or flaretite seals.) The 542 works beautifully. Let it cure for 24 hours prior to use. I use it on all the high pressure fittings: apply with Q tip to the

Hi Dean, I recently replaced the end caps on the outboard end. In so doing I took the whole membrane frame out. It is not difficult…nor is it something to be fearful of... However from your photos

Hi all, I've been monitoring some surface corrosion on the HP wastewater connector of my Dessalator Duo 100 watermaker. I knew there must be a leak, but I've never observed any actual water coming

Dear all, Based on your replies, it does appear that what I had assumed to be a “grounding plate” (please see the attached picture) is in fact an SSB plate… Further to this, it looks like that

Salut François, on my Sharki I use 10 liters of antifouling for 2 generous coats of self-polishing paint and 3 on the rudder and waterline. Good work! Giorgio Ardrizzi sy Saudade III - Sharki #1

Hello Alex, Yes, I received your email. A big thank you to you and Kent Robertson for sending measurements and photographs. I really appreciate you both taking time to do the measurement and sending

When you say "grounding plate" I assume you are talking about the sintered metal plate on the starboard side of the rudder skeg. The "grounding plate" would have been connected to the bonding system

I want to thank everyone that has replied privately! We have been able to get a good look at a Maramu (and the wife likes it!) and are trying to coordinate dates to see a Super Maramu in the next

Alex, Are you speaking of the SSB dynaplates, or the zincs on the rudder? Fair Winds Eric Kimberlite Amel Super Maramu #376

Dear Amelians, I have recently replaced an old and worn out bonding strap in the bilge with a new one, which I made from 3x41mm copper plate, and today I ran all bonding checks as advised by Bill in

Hi Paul, I have actually sent a reply to your private email a few days ago. Did you receive it? Perhaps, it is in your Spam/Junk folder… Cheers, Alex

Hi Mark, Thank you very much for your prompt reply. After having read all the posts on the subject, I have decided on 500A fuse for my new lithium batteries bank. Keeping fingers crossed, it should

This is everything you may need including brush sizes and where to get them Amel Genoa (Final Version) 24v Motor & Brushes.pdf CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 |

It'll be interesting to see how they define continent since it varies by where someone was educated and the countries of the world do not agree on the definition or how many

Bryce, The answer is "it depends." How do you use your boat? If your boat spends most of its life connected to shore power, and if that is the only place you want to use hot water, then an electric

Thanks everyone, it turned out to be the Generator start battery. I have dedicated start batteries for the engine and the generator and confirmed the generator start is dead by cutting off shore power

Aqua Signal 34 navigation lights will run just fine on a normal 24 Volt system, including the absorption charging voltages of close to 29 Volts. We have used them for years without an issue. The only