I had this made in St Maarten. It is held in with a large socket head SS cap screw. When not in use I put it in the port cockpit locker. Fair Winds Eric Kimberlite Amel Super Maramu #376

Bill, I never have had a hard-starting issue. Possibly because I changed all the battery cables a few years ago including everything in the battery box. Fair Winds Eric Kimberlite Amel Super

Bill, You are correct the wires are connected to the + and – Posts on the genset. My question was where the wires go to? As I stated they start at the starter battery cable studs on the

Scotty is good and reliable. He has the bronze gear and one other part. If you only need the bronze gear, he is the guy to contact. CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 |

Parts for rebuilding the inner workings of the genoa furler are also available from: Scotty Robinson Wescon Machining, Inc. 1325 Thomas G. Wilson Drive Conway, Ar. 72032 Ph. 501-327-5236 Fax

The refurbished engine room hatch coming back on-board today, so last chance on the temp one ...

Ditto, although the masse light was intermittent, and impossible to track down, or eliminate using the prescribed methods. Until I replaced the failing switches on the windlass, cleaning up

Are the holding tanks on the 54 built the same as on the SM? I had a system the worked well on plastic holding tanks but not on the fiberglass wood of the SM The system measured the capacitance

Jeffery, I assume you are asking about a Mango swim ladder. I believe your only solution is to have one made. You might be lucky enough to be located where there is a Mango and a fabricator. I am not

Bob Ross is a member since 2017. He sold Nomad about 2 years ago and I believe he bought a trawler. Bill CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston

Amel has not had the rubber angle part in years. Taurus, that is a very good solution! I fit a small piece of hose and a hose quick-connect to the Stainless Steel tube. I found that a short piece of

As some of you may recall, in January I posted a notice regarding the availability of SM Genoa Furler rebuild kits made by the original manufacturer to Amel (OEM). I negotiated a free motor for you

Hi Chris i have had my dodger slightly modified but I can give you the diameter of the 3 ss tube holding it. 22.8mm for the back one and 20.7mm for the 2 smaller one. hope that help -- Nicolas

Hi everyone, I am measuring and planning to do a new dodger / enclosure for my SM... at the yard last weekend and forgot to measure the stainless BOW DIAMETER. Does anyone know this off-had as to

1st time asking a question, where can I find parts or the entire swim ladder / dock boarding ladder. 2nd question: where to find rear motor mounts for my 1980 Mango. Thanks

Eric, The "Hard Start" issue can be caused by several things but is usually a result of added resistance in the circuit between the Onan Starter Motor and the Starting Battery. The resistance comes

Bob, We welded a piece for the Selden sleeve. On the port side, the starboard has a 40kg Rocna. Works well. -- John Bernard "JB" Duler San Francisco Meltem # 19, Western Med

Hi Eric, Do you have a photo or drawings of that bowsprit? Bob, KAIMI SM 429

Was this posted by Bob Ross, SM #362 S/V Nomad? That rig doesn't look like it goes with a Super Maramu. Just scam checking. This is Bob Rossi (currently in Deltaville but living in San Diego) SM429

Made from water pipe. Transparent not armored. Bend the pipe using a heater. sorry not on my boat can't send the pictures. but that's very simple solution.