Hello all, Can someone do me a favor and take a picture of the small, foot operated "peddle" that is used to open the trash cans in the SM head. I have attached a picture of the trash can I have that

I was told that the loop going into the exhaust system was not a good thing. You can't know if it is working or not. I changed the original genset upon purchase as it was not operating. Removal of

Thanks Bill, I have been told by three mechanics and two surveyors that: 1. The vented loop should be vertical not horizontal. 2. The way the vented loop is plumbed into the exhaust hose is not a

Yes, it is on SM2ks and maybe before. CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550 www.AmelOwnersYachtSchool.com Bio &

Nice minimalistic solution. How long do you use it? Is it strong enough? as I understand there is no welding for the main SS tube?

Thank you John. That's a classic solution. I like it. Can you also show the full picture with the other end attachment ?

Hello, I am wondering if the vented loop on the Onan, (MDKAV), generators are all mounted up against the ceiling of the engine room as seen in the attache photo ? This is how the vented loop is

Thanks Bill, Unfortunately, I am too big to get into the space to find the wire. I just remember I have a Fiber optic scope on board, and I will find the bugger in the next few days. Fair

Eric, I know that was your only question and after you answered my question about someone working on the Onan I said "the only thing to do is to trace the wires to see where they go." The reason my

I had this made in St Maarten. It is held in with a large socket head SS cap screw. When not in use I put it in the port cockpit locker. Fair Winds Eric Kimberlite Amel Super Maramu #376

Bill, I never have had a hard-starting issue. Possibly because I changed all the battery cables a few years ago including everything in the battery box. Fair Winds Eric Kimberlite Amel Super

Bill, You are correct the wires are connected to the + and – Posts on the genset. My question was where the wires go to? As I stated they start at the starter battery cable studs on the

Scotty is good and reliable. He has the bronze gear and one other part. If you only need the bronze gear, he is the guy to contact. CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 |

Parts for rebuilding the inner workings of the genoa furler are also available from: Scotty Robinson Wescon Machining, Inc. 1325 Thomas G. Wilson Drive Conway, Ar. 72032 Ph. 501-327-5236 Fax

The refurbished engine room hatch coming back on-board today, so last chance on the temp one ...

Ditto, although the masse light was intermittent, and impossible to track down, or eliminate using the prescribed methods. Until I replaced the failing switches on the windlass, cleaning up

Are the holding tanks on the 54 built the same as on the SM? I had a system the worked well on plastic holding tanks but not on the fiberglass wood of the SM The system measured the capacitance

Jeffery, I assume you are asking about a Mango swim ladder. I believe your only solution is to have one made. You might be lucky enough to be located where there is a Mango and a fabricator. I am not

Bob Ross is a member since 2017. He sold Nomad about 2 years ago and I believe he bought a trawler. Bill CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston

Amel has not had the rubber angle part in years. Taurus, that is a very good solution! I fit a small piece of hose and a hose quick-connect to the Stainless Steel tube. I found that a short piece of