I am in Singapore and found a company that services Halon fire suppression systems. I need to find the Halon canister. I had assumed that it was the small canister in the ceiling of the engine room.

That should have said rogue wave is our agent in Annapolis Regards Richard Piller [Non-text portions of this message have been removed]

Nope its not the keel the rudder or even the boom BUT the headlining i suspect :-) when the heat gets to the foam backed vinyl linings they do more than droop. regards David [Non-text portions of

I'm going to show my inexperience again...Amel droop? Kent SM 243 KRISTY

We have a 1979 Amel Maramu in which we are just about to do the same as yourselves! We have had the hull checked out and it is sound we have of course had some refitting to do but rest assured we have

Hi, markerdos, I've owned "Kristy" for 2 1/2 years now.  She's a 1999 SM2000 hull #243.  She sat essentially unused on a lake in Texas for 5 years or so before I bought her.  I've had to add new

Rough way in Annapolis has our 1998 listed have a look. She is ready to go. Even a full fuel tank. Regards Richard Piller [Non-text portions of this message have been removed]

Dear Amel Owners, My wife and I are about to fulfill our life-long dream and enter the world of full time cruising. We have saved and sacrificed over the years to finally reach this point. We have

Hi Frank, The code was given to me by the Service Centre at Hyeres, I gathered from that conversation that Amel have always used the same colour, though it may me worth contacting them to

Graham Would you happen to know if the quoted Renault White 348 as used on the Sharki masts is the same paint code Amel applied on the Super Maramu 2000? Frank Newton SM 2K 321 'Bootlegger

Bill, I have contacted the main B&G support in Viareggio. They told me that the neoprene extension is mainly for protection of the transducer. For now you can sail but you have to keep it cleaned,

For those who may be considering re-painting or making repairs to the mast/boom paintwork. Renault White 348 is the paint code that I believe to be correct. It certainly matches the existing colour

I guess that settles that so much for the eyeball test on this one. Regards Richard Piller

Bill in the forward cabin there is a through hull sending unit for the speed sensor You can remove it ( be sure to have a wood plug to fit the hole) and replace the unit. I simply don't know If the

FYI, I received the following email from Boris COMPAGNON at Amel After Service: "The rubber bumper you have in hands is just a protection cover of the sensor. If this not in place, you may find the

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /B & G Sonic Speed

By way of follow up on this project: The 24 meter cable as supplied by B&G as part of the masthead receptacle is indeed long enough for the job on the Amel SM 2000. The wires go to a junction box in

Richard, It is the upper hull-mount sensor i.e the rear facing sensor. Bill s/v BeBe

Hi Bill, go to http://www.bandg.com/upload/BandG/Documents/Manuals/sonicinstall.pdf It is a Manual we have not normally on board. There is a sketch of the sensor and of its neoprene cap. Tomorrow -

Bill this looks like the lens and and cover. Can or will you please confirm that your photo is from the "upper" hull mount sensor and not the keel unit. I think if it is the upper you can access-it