Ours is a different Jabsco, don't have the numbers to hand. Regards Danny Ocean Pearl SM299

We got our brushes from a back street shop in St John, Antigua, got the bearings and seals there too. Seemed that they and the brushes were a common size because that certainly was not an " Amel

Hmmmm, Hi "other" Tom.  Do you have the button-type latches or the rectangular ones? Kent SM243

Hi, Tom, I wasn't able to find the brushes either. I own SM243 and asked Amel about the cabinet latches. They said they were no longer available from any source.  I have the rectangular ones with

Hey Kent, Sailing south you won't need the heaters - problem solved :-) I'd guess the 110v feed is an add-on by the former US owner of Kristy, not original Amel, correct? What wattage are you

Can't help on the brushes - but Amel just confirmed to me that they can still supply the cabinet latches.

I've heard that "any good alternator shop" advice on getting brushes for these motors.......tried that and the place everyone recommends/uses in Annapolis wasnt much help. Has anybody actually

I have just serviced my AMFA fresh water pump and am now ready to install. Does anybody know if the pump is self priming? John SM 391

Hi Danny, You are right, the Jabsco 50890 comes in 12v and 24v versions, can be run dry, 5gal/19L/minute and primes to 3 meters. Can be purchased for as little as $170-$225 US. Only restriction is

http://www.internationalyachtservice.de.tl

I have recently had an electrical survey done on KRISTY (SM243). There were two issues that the ABYC electrician found that concerned him. First and most important to him is the size of both the

Hi Kent Jabsco make an electric diapragm bilge pump that can do the job well, just get several spare joker valves, thats about all that goes wrong with it. Regards from Danny and Yvonne on Ocean Pearl

Thanks for that advice, John.  I've already had a fitting for the mizzen foil made and one for the forestay that are nicer than the originals.  This is a plastic housing that I'm going to try to

Kent, As you travel around the world you will find that a machine shop is your best friend. They can fix anything and they can make anything. Take the broken piece to them, they will fix it in a few

Kent I installed the Nautic Quick 40 liter 230v a few months ago.Seems like a great unit,easily fit the area and is a good value when compared to other heaters.I think I bought mine from

Mike thanks for the note. I think at based on the 12 GPM of the new pump or 60 times that it makes for a better bilge pump. My original fail after 11 year not a bad run. But we were not able to find

Thank you, gentlemen.  I just got your replies after I posted again with ?'s about the water heater.  Richard, I'm amazed that the macerator pump will self prime the 5 ft or so from the bottom of

Hi all. Hope you are gearing up for a great holiday season. I just got back from the boat, having discovered another problem (isn't there always another one?). After finding the bilge pump running

Richard,  If it is any help, attached is the exploded diagram of the PAM pump with the manufacturers details. Mine has been on my Santorin for 20 years, and is getting close to it's "sell by"

You will Find all the information you require from the manufacturer below. We recently purchased maintenance kits for the bilge and fresh water pumps without difficulty and with excellent