Dear Bob, If the power post on the dock has two 30 amp 120 volt outlets it most likely has a 240 volt outlet that takes a 50 amp plug as I described. Just return the cord and “y” adapter and get

My posting earlier may not have been clear. My boat, a 1993 Santorin, is presently in the Annapolis area and I am needing to provide 220 volts (which my Santorin is wired for) from the 110 volts

Gary, That is correct. That is the way I wired Kimberlite. Please note that he USA white and green are at the same potential. If you happen to check the voltage (when plugged into a 220 volt

between USA and European power for some time. I had some questions about this posting and would like to state my understanding and have those in the know do a reality check for me. ( NOTE that

for those of you who opted for the espar heater option. what sixe (btu) is it and how and where is it mounted? thanks eric sm kimnerlite #376

Bob, Numerous things on a new Amel do not meet abyc standards. Remember this is a French boat and meets all the European standards. ABYC is not the only standard in the world. I have investigated the

Why don't you just disconnect the European connector and install a 50 amp 220 volt connector and return the expensive "y" connector and cord? Eric

I had a few AC related questions and thought I would link them to this earlier discussion about AC power. I've purchased a Marinco "reverse Y" for my 1993 Santorin and have a couple of questions.

The solent stay is attached to the mast just 3 feet from the masthead, thus no runners were needed. The maramu had only a single spreader rig and small foretriangle, so this worked well. The

Dear Ben, Thank you very much for the info. How was the solent stay rigged. What did you attach it to and how did you strengthen the deck and below deck fittings? Did you install running

Hi, new to the forum... My father, brother and myself sailed our 1983 Maramu Resolute from Alaska to Cape Horn and back in 1998-2000. Our website is www.paonline.com/resolute For heavy weather we

Hallo George, I have the same problem in my SM 107 and I solve it. The first thing that you have to do is to check with an expert in electronic if your autopilot software is the last version that is

Unfortunately yes, my ST7000 had a major failure. The main PC board went bad. There was no way to get it working as it decided to announce "low batteries" and bip for ever as soon as I would try to

Hi to all that have emailed. I shall answer everyone in one email to keep downlaod to the minimum for those who might be on a Sat phone. Eric Regarding the poles, I simply hang them on the rails.

Delores, are you talking about protecting and polishiing the stainless steel deck guard rail here ? Im finding it difficult to get this job done. help appreciated, Dennis Woods Co owner Khamsin B

Message text written by INTERNET:amelyachtowners@... Dear Ian and Judy, Thanks for your info. To see the pics open "photos" and then click on the thumbnail marked Bali Hai. Of our

hi, does anyone have factory pictures of the Amel factory . I have already seen the existing ones on the yahoo website. thanks fair winds eric freedman sm 376 kimberlite

Hi Ian, The 303 product is clear and would not be a problem as far as the "grain" goes. But I doubt I would use on the faux teak decks as it might be slippery. It would effectively prevent the

Dear Anne and John, I am interested to see your cockpit chair pictures , but being somewhat of a novice on a computerI am struggling to find them---what do I do to download them? You have my