Eric, Leroy Sommers is still the place to get these from. Outhaul and furling motors and gearboxes are identical, BUT.... Leroy Sommers has changed the motor design--and, confusingly, kept exactly

Hi Martin, Many thanks, a very comprehensive explanation. If I am not asking too much of your patience, how do you manage helming in the stand up position? Has the seat a back-folding bottom cushion

Thank you for the help and suggestions. This wentpretty well. Like Mark’s, my aft tank ball-valve was not glassed in like thefront. A massive set of channel locks is definitely the right tool

I have a set of spare parts for original furler. Call or write me if you need one. I am a previous owner of Amel Supper Maramu " Life is Good" Vladimir. 202-258-1916.

Hi Joan, hi Paolo, the model is Besonzoni Pilot Seat P 246 Amel (meaning special width) fabric: silvetek graphite Logo: Amel If you look to the catalogue you will not find exactly this helm seat.

We had to replace the Bamar EJF-1 about 4 weeks ago that was installed approximately 3 ½ years ago. Water intrusion seemed to have incurred at an unknown location causing what appeared to be

Christian, There are two brass/bronze fittings on the bottom of the black water tank, input and output. The output referred to in this thread does not have anything inside the tank that is attached to

Hi, On our recent passage from NY to St Maarten our outhaul motor got wet, When I went to my spares, I had a brand-new Leroy Sommer motor . Unfortunately, it was too small in diameter. Are the

Hello there, another follow up question from a newbie owner… what did you put inside on the other end of the 1.5” to 1.5” hose barb to hose barb fitting? Did you use hose, or a section of PVC

I read that in an earlier post. I do not believe any of the Onan models have a fuel cut-off solenoid. I believe most of them have a throttle actuator governor which when all the way closed acts as a

Kent and Iris, I am a new Amel owner and am on a mooring off the Palm Beach Sail Club. I live nearby and have a car. Let me know if I can help. Richard Dallett A54 68

Bob, Fuel solenoid or fuel pump? Fair Winds ERIC Kimberlite Amel SM 376’

Does anyone have the part number for the MDKAV fuel solenoid? I assume it is the same as the MDKAL but can't locate it in the pdf of my parts manual. I'm thinking a spare belongs in my kit.

All, Amel-designed Genoa Electric Furler: As you may be aware there are no Amel-designed Genoa furlers available and there are only a few of the parts available from the Swiss guy who manufactured

Well done Martin. I am trying to visually adapt your 54 cockpit arrangement to my SM but probably is feasible. It is not entirely clear to me from the picture how you manage the table stand and the

Hi Martin, Your helm seat solution looks great. I particularly like it because you have chosen original Amel parts. With the 55 the helm seat is fitted on top of the extended cockpit port bench. So

Try a piece of rigging in the drill open the end a bit it will chew out anything. Cheers Courtney Trippin 54#101

We replaced our microwave with an inexpensive 110volt and run it off the inverter. We use the microwave all the time. Warm up left overs, warm precooked meals, microwave egg for our version of an egg

Hi Mark, Unfortunately, I don't remember specifically what tool I used to remove the gelcoat from the ball valve, but I do remember it came off easier than I would have expected. Use Blue Monster